A Project Report on
Simulation Testbed for Evaluation of
Critical Software in Launch Sequence
Submitted in Partial fulfillment of the requirements for the award of
the degree of
Master of Technology
In
Software Engineering
Submitted by
Sreebal I S
Under the Esteemed Guidance of
Mr. Santhosh Kumar G
Lecturer
Dept. of Computer Science, CUSAT
DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY,
KOCHI-682022, KERALA
JUNE 2008Page 2
Page 3

DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND ....etc

[:=Read Full Message Here=:]

Assume that you are assigned responsibility of developing an Examination Form Submission System (EFSS). EFSS will have all necessary fields that are essential for generation of a Hall Ticket without any errors. After Examination Form is submitted, the data needs to be validated by EFSS. If the data is valid, then Hall Ticket should be generated. Appropriate e-mail should be sent to student in all cases. Make necessary assumptions.Develop SRS using IEEE format ....etc

[:=Read Full Message Here=:]

Embedded systems are computing devices that are radically different from normal desktop computers in terms of the specific requirements of the application for which they are used. Characteristics such as reactivity, robustness, power, size and cost issues force certain design constraints which are otherwise obviated or trivial. Traditional computer design methodologies do not fully address essential design issues critical to system requirements. Certain issues peculiar to embedded systems have been identified and a few possible guidelines to r ....etc

[:=Read Full Message Here=:]

Concrete is an indispensable construction material of modern age. The properties of concrete are greatly dependant on the constituents, workmanship, water-cement ratio, compaction, curing etc. Direct assessment of the strength of concrete is not possible because direct tests induces destructive stresses and causes failure of the structure. So the concrete strength is tested using standard specimens made with the same mix as that of the structure. But the test specimens can vary from the actual structure in properties due to difference in compac ....etc

[:=Read Full Message Here=:]

DETERMINING THE CRITERIA FOR
EVALUATION OF TOXIC HAZARDS
SREERAJ R NAIR
PRINCIPAL ENGINEER
CONSULTANCY SERVICES
AKER SOLUTIONS, UK
Email “ [email protected]
Introduction
Industries handling dangerous materials continuously
identify hazards and manage risk. One of the major
hazards in process or manufacturing industry is the
release of toxic chemicals. The hazard arising from a
toxic release depends on the toxicity of the chemical
and the conditions of exposure. The effects from the
exposure to toxic release c ....etc

[:=Read Full Message Here=:]

Titanium matrix composites (TMCs) have been extensively evaluated for their potential to replace conventional superalloys in high temperature structural applications, as they provide significant weight-savings while maintaining comparable mechanical properties. Gamma titanium aluminide alloys and an appropriate fiber could offer an improved TMC for use in intermediate temperature applications (400-800°C). The purpose of this investigation is aimed at evaluating the potential of a gamma titanium aluminide alloy with nominal co ....etc

[:=Read Full Message Here=:]

Evaluation of the Power Consumption of
Routing Protocols
for
Wireless Sensor Networks
# G. Santhosh
Kumar*
, Lino Abraham Varghese ,
Jose
Mathew
K
and
K.
Poulose
Jacob*
Department of Computer Science,
Cochin
University of Science
and
Technology
Cochin, Kerala, INDIA, *{san, kpj}@cusat.ac.in
Abstract
implosion problem experienced by Flooding
as
only
one copy
Sensor
networks
are one
ofthefastest growing
areas in
broad of
a
packet
is in transit
at
any
one
time.
In
GBR, each node in the network
can
look
at ....etc

[:=Read Full Message Here=:]

Concrete is an indispensable construction material of modern age. The properties of concrete are greatly dependant on the constituents, workmanship, water-cement ratio, compaction, curing etc. Direct assessment of the strength of concrete is not possible because direct tests induces destructive stresses and causes failure of the structure. So the concrete strength is tested using standard specimens made with the same mix as that of the structure. But the test specimens can vary from the actual structure in properties due to difference in compac ....etc

[:=Read Full Message Here=:]

Definition
This paper addresses the issue of exam paper evaluation using neural network. This paper foresees the possibility of using adaptive real time learning through computers viz. the student is made to feed his answers in a restricted format to the computer to the questions it puts up and the answers are evaluated instantaneously. This is accomplished by connecting the computers to a Knowledge Server. This server has actually connections to various authenticated servers (encyclopedias) that contain valid information about all the subject ....etc

[:=Read Full Message Here=:]

Embedded systems are computing devices that are radically different from normal desktop computers in terms of the specific requirements of the application for which they are used. Characteristics such as reactivity, robustness, power, size and cost issues force certain design constraints which are otherwise obviated or trivial. Traditional computer design methodologies do not fully address essential design issues critical to system requirements. Certain issues peculiar to embedded systems have been identified and a few possible guidelines to re ....etc

[:=Read Full Message Here=:]