Abstract
Introduction.
Proximal tibial bony deficienciesare frequent conditions in primary and revision total kneearthroplasty. Modular tibial metal augmentations wereintroduced to address these deficiencies hoping that they arebetter than other methods of reconstruction (cementreinforced with screws or structural bone graft).
Material and Methods.
During Jan 2000-Jul2009, 407 total knee arthroplasty were performed in ourdepartment. 24 patients had a varus alignament of the kneemore than 25°. For replace..............etc

[:=Read Full Message Here=:]

Cost effective and reliable damage detection is critical for the utilization of thin layered materials and microstructures.This Thesis presents a brief overview of conventional NDT methods and the usage of unconventional NDT methods applicable to thin layered materials, and the conclusion of applicability of these methods for damage detection in thin layered materials

http://projectsparadisedefects-thin-layered-materials/# ..............etc

[:=Read Full Message Here=:]

Demand for the research and development of the micro-manufacturing technologies is being fueled by the ever-increasing trend towards miniaturization over a wide spectrum of disciplines and industries. Recent technological advancement in the defense, biomedical, telecom-munications, consumer electronics have spearheaded the need for micromanufacturing technology, which is now beginning to find application in the automotive and aerospace industries due to the economic potential of the micro-factory paradigm. Micro-scale mechanical manufacturing p..............etc

[:=Read Full Message Here=:]

A NEW REDUCED SIZE MICROSTRIP PATCH ANTENNA WITH FRACTAL SHAPED DEFECTS



Abstract—With development of communication with integration
technology, size reduction of microstrip antennas is becoming an
important design consideration for practical applications. Here a new
microstrip antenna with Koch shaped fractal defects on the patch
surface is presented. Using this method, the overall electric length
of the antenna is increased largely and hence the size..............etc

[:=Read Full Message Here=:]

The effect of sub surface defects in surface roughness monitoring through ultrasonic flaw detector.
Objective
 To study the effect of sub surface defects in surface roughness monitoring through ultrasonic flaw detector.
 To study the sizing of defects.
Ultrasound Concepts
• All sound waves, whether audible or ultrasonic, are mechanical vibrations involving movement of the medium in which they are traveling. A sound wave may be transmitted through any material which behaves in an elastic manner.
..............etc

[:=Read Full Message Here=:]

ESTIMATION OF DEFECTS BASED ON EFECT DECAY MODEL: ED3M-- SOFTWARE ENGINEERING

An accurate prediction of the number of defects in a software product during system testing contributes not only to the management of the system testing process but also to the estimation of the productâ„¢s required maintenance. Here, a new approach, called Estimation of Defects based on Defect Decay Model (ED3M) is presented that computes an estimate the defects in an ongoing testing process. ED3M is based on estimation theory. Unlike many existing appr..............etc

[:=Read Full Message Here=:]

This work proposes a new, software-based, defect detection and diagnosis technique. We introduce a novel set of instructions, called Access-Control Extensions (ACE), that can access and control the microprocessorâ„¢s internal state. Special firmware periodically suspends microprocessor execution and uses the ACE instructions to run directed tests on the hardware. When a hardware defect is present, these tests can diagnose and locate it, and then activate system repair through resource reconfiguration. The software nature of our framework ma..............etc

[:=Read Full Message Here=:]

want the complete power point presentation of the mentioned topic..............etc

[:=Read Full Message Here=:]

Hi to all

I am doing project on Estimation of Defects Based on Defect Decay Model
I completed all modules except the 3rd Module that is Error Estimation module, i don't know how to proceed for that module.

Can any one help to complete that task???????


Waiting for quick reply

Thanking you...............etc

[:=Read Full Message Here=:]

Please send me complete report,abstract and details of this project..............etc

[:=Read Full Message Here=:]