Application of fayol's principles of management in big bazaar..............etc

[:=Read Full Message Here=:]

1.The engine runs in a dosed garage can be dangerous because :
(A)The exhaust gas contains carbon monoxide
(B)The exhaust gas contains carbon dioxide
(C )The exhaust gas contains water vapour
(D)The exhaust gas may catch fire

2.Which of the following should not be done by a good mechanic?
(A)Put sharp edged tools in the pocket
(B)Wipe excess oil and grease off the hands and tools
(C )Always keep the workshop floor dean
(D)Wear safety goggles while grinding

3.‘Which of the following is not used in fire extingui..............etc

[:=Read Full Message Here=:]

Hi Sir

Iam a student and studied in the school, i have given a project to know about your orgainisation principals of management
1. Division of work
2. Unity of commanc
3. Unity of direction
4. Scalar chain
5 Fair remuneration to all..............etc

[:=Read Full Message Here=:]

How does the principle of division is followed by haldirams?..............etc

[:=Read Full Message Here=:]

How fayol's fourteen principles are applied in VISHAL megamart? I want to know the answer of this question so please help me..............etc

[:=Read Full Message Here=:]

how division of work takes place in reliance fresh?..............etc

[:=Read Full Message Here=:]

171/2015
Maximum : 100 marks
Time : 1 hour and 15 minutes

1.Which of the following is not the objective of internal check?
(A)Division of work among the staff
(B)Error and fraud are automatically detected
(C )Prevention of error and frauds
(D)Allow the staff to do any single work from beginning to end

2.Right shares enjoy preferential right as regards :
(A)Payment of retained earnings
(B) Payment of dividend
(C ) Payment of capital
(D) None of the above

3.Which of the following methods of inventory valuat..............etc

[:=Read Full Message Here=:]

1. The curve_______is commonly used in teeth profile of helical gears, profile of cams etc.
(A) Spiral (C ) Involutes
(B)Helix (D) Cycloid

2.The standard size length to width ratio for all arrow heads in drawings is :
(A)2:1(B)4:1
(C )3:1(D)2:4

3.In a whole circle bearing system, S 25° 15” E corresponds to :
(A)115° 15’(B)154°45’
(C )205° 15’(D)334°45’

4. The image formed by the objective in the plate of cross hairs is :
(A)Real and Straight (C ) Contour interval

5.The main principal of surve..............etc

[:=Read Full Message Here=:]

1._________________is provided on the road edge to serve as a emergency lane for vehicles compelled to taken out of the pavement.
(A)Kerb(B)Shoulder
(C )Carriage wayCarriage way(D)Gradient

2.The brick laid with its breadth parallel to the face of awall is known as :
(A)Stretcher bond(B)Zigzag bondZigzag bond
(C )Garden wall bond(D)Header bondHeader bond

3.Bearing pile is situated in :
(A)Hard stratum(B)Water
(C )Above ground levelAbove ground level(D)None of these

4.The camber provided for gravel road is :
(A)..............etc

[:=Read Full Message Here=:]

hii...i am sreepriya..and i would like have the details of principles of management applied in AMUL..............etc

[:=Read Full Message Here=:]