sir, plz give me the tecnical details about the design and fabrication of two wheeler with propeller shaft mini project.
tell me about its parts and spares used to make design and fabrication of two wheeler with propeller shaft.
sir plz tell abot this mini project of design and fabrication of two wheeler with propeller shaft mini project ..............etc

[:=Read Full Message Here=:]

design , experimentation and investigation of composite propeller shaft used aerospace industries using ansys and autocad software..............etc

[:=Read Full Message Here=:]

i am final year mech can i
do this project ..............etc

[:=Read Full Message Here=:]

During the running process of eccentric powder machine, the fineness of the final products is a very important parameter. However, due to some reasons, the product fineness cannot satisfy the requirements of the customers,belt conveyor for sale for sand and gravel so that it is necessary to adjust the product fineness which can be realized from the following two aspects:

1. Adjust the cycle air quantity of the powder machine

The adjustment of the cycle air quantity relies on the amount of the big and small air blade. When the final p..............etc

[:=Read Full Message Here=:]

Under the Guidance of Dr. Patil Basavaraj VDept of IP & E
Submitted By Deepak Kothari

Introduction to CWR

The CWR is a rotary forming process, consists
of the forming of forging by means of wedge-shaped tools that are fixed on the mill rolls with the same rotary direction.
In CWR process, there are five stages in the work piece deformation process corresponding to five zones of the wedged tool geometry, i.e., knifing, guiding, stretching, shaping, and siz..............etc

[:=Read Full Message Here=:]

sir,i'm in final year student,iknow pro-e as design software & i want to do my project on design & analysis of crank shaf using ansys. ..............etc

[:=Read Full Message Here=:]

Hi am Nikhil i would like to get details on pdf file for eccentric network for intranet and now i am living at bangalore and i last studied in the school narayana and now i am doing engeneering i need help on this project...............etc

[:=Read Full Message Here=:]

Hello,

I'm Hariharan from PSG Tech. I saw the list of automobile projects that was available and the topic DESIGN AND FABRICATION OF PROPELLER SHAFT AND TIE ROD BEND TESTING AND BEND REMOVING MACHINE caught my eye.
I'm interested in knowing more on this project, i.e instructions on how to build it and its report.
I've planned to select this topic for my mini project, so an earlier reply will be much appreciated.

Regards
..............etc

[:=Read Full Message Here=:]

Design and analysis of crank shaft 4s S.I engine.

ABSTRACT
In this project we designed and analyzed a crankshaft of 4-stroke S.I engine using Ansys, which is software, which works on the basis of finite element method.
Firstly, we created a solid model of the crankshaft using designing software PRO/E. Then the model is imported into Ansys and analyzed by applying necessary conditions, which were considered in designing it and then checked for the strength and life. The specifications required for the design are taken from the dra..............etc

[:=Read Full Message Here=:]

i dont want a job i just need thye information about this project...............etc

[:=Read Full Message Here=:]