20-09-2009, 02:39 PM
[attachment=2392]
INTRODUCTION
Cellonics allow modem speeds 1,000 times faster than our present modems.
It is based on the way biological cells communicate with each other and nonlinear dynamical systems (NDS).
Benefits are incredible speed, simplicity, and robustness.
The ASCII uses a combination of ones and zeros to display a single letter of the alphabet The data is sent over radio frequency cycle to its destination where it is then decoded.
Human cells respond to stimuli and generate waveforms that consist of a continuous line of pulses separated by periods of silence. The cellonics technology uses these pulse signals and apply them to the communications industry.
Nonlinear Dynamical Systems (NDS) are the mathematical formulations required to simulate the cell responses .
It uses portable devices, and provide these devices with faster, better data for longer periods of time .
It consume very little power.
PRINCIPLE OF CELLONICS TECHNOLOGY
Cellonics -electronic cells.
It has the ability to encode, transmit and decode digital information over a variety of physical channels, be cables or wirelessly through the air.
The cellonics technology is a fundamental modulation and demodulation technique. The Cellonics receivers generate pulses from the received analog signal and perform demodulation based on pulse counting and related algorithms.
1. The study of biological cell behaviour is only an inspiration to the invention of Cellonics circuits. The Cellonics technology is not related to any neural network communications or neurophomic electronics.
2. Slow waveforms: Analogue waveforms that vary slowly with time. These waveforms can be in any arbitrary shape.
3. Fast waveforms/fast pulse trains: Waveform in the shape of pulses that varies rapidly with time.
Transfer characteristic consists of three different regions.
The two lines at the top and bottom have positive slope.
1/RF and they represent the regions in which the Op-Amp is operating in the saturated (nonlinear) mode.
The middle segment has a negative slope(Op-Amp operate linearly).
dVs/dt = (V0 depending on the slope of the triangular input waveform.
slope is positive, the Op-Amp is stable- outputs a constant saturation voltage.
When slope is negative- the Op-Amp is unstable- the output is oscillating.
By controlling the duration of the negative slope, he number of pulses to be produced at the output of the Op-Amp can be controlled.
a) BER Performance in a Narrowband Communication System
The BE performance of the Cellonics modulation is able to match the theoretical optimal BPSK modulation scheme .
Cellonics receiver will have less implementation losses
b)BER Performance in an Ultra Wideband
UWB is a new radio system that occupies an ultra wide bandwidth and it uses very short impulses of radio energy.
It will cause little interference to the existing spectrum users.
Narrowband Communication System
In this system, a CD-ROM player is used as a convenient signal source to provide the required bit stream. The digital data is modulated using a pulse width modulation scheme. These modulated data are then passed through a700-ft telephone wire line. At the receiver, the data is demodulated using the N-shaped Cellonics circuit, which uses only two elements - an inductor in series with a tunnel diode. To recover the digital information, the decision device simply counts the pulses to determine if it is a logic ˜1™ or ˜0™. The recovered data is then output to an audio player for real .
Narrowband Communication System (Wireless)
Transmitter and receiver comprise of three modules:
1.The PC/DSP module :provides a high-speed data transmission interface with the transmit/receive PC .
2.Base band transceiver module: converts these data from the DSP into FSK-like waveforms.
3.The RF transmit/receive module:down converts the received signal using an AM envelope detector.
Ultra Wideband Audio System
This system demonstrates the live transmission of compact disc music using UWB wireless technology.
Digital data from two CD-ROM players is tapped at a rate of 11.4 Mbps. This data stream is fed into a UWB pulse generator and transmitted wirelessly. At the receiver end, the signal is detected and then fed to a Cellonics receiver to decode and the original music data is recovered/sent to an audio player for real-time playback .
Ultra Wideband Video System
Transmits real-time video images at a data rate of 12Mbps wirelessly to a video monitor.
A simple web camera is used as the video capture source. The digital video information is fed into a pulse position modulation processing board (a Field Programmable Gate Array or FPGA board) via a USB connection before being frequency translated to a higher frequency band at a transmitter for sending over the air. The airborne signals are then detected by a UWB receiver and pulse position demodulated back into digital video information for display at a video monitor. In both instances, an ultra simple Cellonics Transmitter and a simple Celloncis receiver are used. The speed of the system is only limited by the Video cameraâ„¢s USB interface data rate.
CELLONICS ADVANTAGES
New Life to Communication Devices .
Savings on Chip/ PCB Real Estate.
Savings on Power .
Savings in Implementation Time .
Build or Rejuvenate your Products with Cellonics .
CONCUSION
The Cellonics communication method is one inspired by how biological cells signal.
With the Cellonics method, noise-generating and power-consuming systems such as voltage-controlled oscillators, PLLs, mixers, power amplifiers, etc., are eliminated.
INTRODUCTION
Cellonics allow modem speeds 1,000 times faster than our present modems.
It is based on the way biological cells communicate with each other and nonlinear dynamical systems (NDS).
Benefits are incredible speed, simplicity, and robustness.
The ASCII uses a combination of ones and zeros to display a single letter of the alphabet The data is sent over radio frequency cycle to its destination where it is then decoded.
Human cells respond to stimuli and generate waveforms that consist of a continuous line of pulses separated by periods of silence. The cellonics technology uses these pulse signals and apply them to the communications industry.
Nonlinear Dynamical Systems (NDS) are the mathematical formulations required to simulate the cell responses .
It uses portable devices, and provide these devices with faster, better data for longer periods of time .
It consume very little power.
PRINCIPLE OF CELLONICS TECHNOLOGY
Cellonics -electronic cells.
It has the ability to encode, transmit and decode digital information over a variety of physical channels, be cables or wirelessly through the air.
The cellonics technology is a fundamental modulation and demodulation technique. The Cellonics receivers generate pulses from the received analog signal and perform demodulation based on pulse counting and related algorithms.
1. The study of biological cell behaviour is only an inspiration to the invention of Cellonics circuits. The Cellonics technology is not related to any neural network communications or neurophomic electronics.
2. Slow waveforms: Analogue waveforms that vary slowly with time. These waveforms can be in any arbitrary shape.
3. Fast waveforms/fast pulse trains: Waveform in the shape of pulses that varies rapidly with time.
Transfer characteristic consists of three different regions.
The two lines at the top and bottom have positive slope.
1/RF and they represent the regions in which the Op-Amp is operating in the saturated (nonlinear) mode.
The middle segment has a negative slope(Op-Amp operate linearly).
dVs/dt = (V0 depending on the slope of the triangular input waveform.
slope is positive, the Op-Amp is stable- outputs a constant saturation voltage.
When slope is negative- the Op-Amp is unstable- the output is oscillating.
By controlling the duration of the negative slope, he number of pulses to be produced at the output of the Op-Amp can be controlled.
a) BER Performance in a Narrowband Communication System
The BE performance of the Cellonics modulation is able to match the theoretical optimal BPSK modulation scheme .
Cellonics receiver will have less implementation losses
b)BER Performance in an Ultra Wideband
UWB is a new radio system that occupies an ultra wide bandwidth and it uses very short impulses of radio energy.
It will cause little interference to the existing spectrum users.
Narrowband Communication System
In this system, a CD-ROM player is used as a convenient signal source to provide the required bit stream. The digital data is modulated using a pulse width modulation scheme. These modulated data are then passed through a700-ft telephone wire line. At the receiver, the data is demodulated using the N-shaped Cellonics circuit, which uses only two elements - an inductor in series with a tunnel diode. To recover the digital information, the decision device simply counts the pulses to determine if it is a logic ˜1™ or ˜0™. The recovered data is then output to an audio player for real .
Narrowband Communication System (Wireless)
Transmitter and receiver comprise of three modules:
1.The PC/DSP module :provides a high-speed data transmission interface with the transmit/receive PC .
2.Base band transceiver module: converts these data from the DSP into FSK-like waveforms.
3.The RF transmit/receive module:down converts the received signal using an AM envelope detector.
Ultra Wideband Audio System
This system demonstrates the live transmission of compact disc music using UWB wireless technology.
Digital data from two CD-ROM players is tapped at a rate of 11.4 Mbps. This data stream is fed into a UWB pulse generator and transmitted wirelessly. At the receiver end, the signal is detected and then fed to a Cellonics receiver to decode and the original music data is recovered/sent to an audio player for real-time playback .
Ultra Wideband Video System
Transmits real-time video images at a data rate of 12Mbps wirelessly to a video monitor.
A simple web camera is used as the video capture source. The digital video information is fed into a pulse position modulation processing board (a Field Programmable Gate Array or FPGA board) via a USB connection before being frequency translated to a higher frequency band at a transmitter for sending over the air. The airborne signals are then detected by a UWB receiver and pulse position demodulated back into digital video information for display at a video monitor. In both instances, an ultra simple Cellonics Transmitter and a simple Celloncis receiver are used. The speed of the system is only limited by the Video cameraâ„¢s USB interface data rate.
CELLONICS ADVANTAGES
New Life to Communication Devices .
Savings on Chip/ PCB Real Estate.
Savings on Power .
Savings in Implementation Time .
Build or Rejuvenate your Products with Cellonics .
CONCUSION
The Cellonics communication method is one inspired by how biological cells signal.
With the Cellonics method, noise-generating and power-consuming systems such as voltage-controlled oscillators, PLLs, mixers, power amplifiers, etc., are eliminated.
