18-10-2010, 04:12 PM
[attachment=6489]
TIME OPERATED SOLAR TRACKING SYSTEM
Objective:
Commercial made solar trackers are a nice addition to any solar panel array. They help increase the time that panels directly face the sun and allow them to produce their maximum power. Unfortunately they can be expensive to buy. We decided to make our own solar tracker to see if we could reduce the cost. We did not want to re-invent the wheel but wanted to make it more affordable. We started out small and came up with the idea of solar tracking using time instead of using a device that would sense where the sun is and move the panels toward it.
The objective of this project is to control the position of a solar panel in accordance with the motion of sun. Brief Methodology: This project is designed with solar panels, RTC, Microcontroller, Stepper Motor and its driving circuit. In this project RTC is used to find or the location of Sun. It’s a open loop system. 1) INTRODUCTION Renewable energy is rapidly gaining importance as an energy resource as fossil fuel prices fluctuate. At the educational level, it is therefore critical for engineering and technology students to have an understanding and appreciation of the technologies associated with renewable energy.
One of the most popular renewable energy sources is solar energy. Many researches were conducted to develop some methods to increase the efficiency of Photo Voltaic systems (solar panels). One such method is to employ a solar panel tracking system. This project deals with a RTC based solar panel tracking system. Solar tracking enables more energy to be generated because the solar panel is always able to maintain a perpendicular profile to the sun’s rays. Development of solar panel tracking systems has been ongoing for several years now. As the sun moves across the sky during the day, it is advantageous to have the solar panels track the location of the sun, such that the panels are always perpendicular to the solar energy radiated by the sun. This will tend to maximize the amount of power absorbed by PV systems. It has been estimated that the use of a tracking system, over a fixed system, can increase the power output by 30% - 60%. The increase is significant enough to make tracking a viable preposition despite of the enhancement in system cost. It is possible to align the tracking heliostat normal to sun using electronic control by a micro controller. Design requirements are: 1) during the time that the sun is up, the system must follow the sun’s position in the sky. 2) This must be done with an active control, timed movements are useful. It should be totally automatic and simple to operate. The operator interference should be minimal and restricted to only when it is actually required. The major components of this system are as follows.
