15-01-2018, 03:28 PM
Since the main / coil assemblies are somewhat different among manufacturers, the following recommendations should be used as the starting point for continuous continuous casting process. Crosslink Technology Inc. Many make up casting systems, which look closely to achieve excellent results in case of crank resistance, partial discharge and accuracy.
Depending on the design and construction, whether or not the pillows are employed, some devices may require more or less hard compounds
General Recommendation:
Minimize the number of edges of pillow (no choice), intense edges by cushioning may cause micro-cracks in the encapsulant during the treatment process.
Remove sharp edges with curved insulation.
Recommended minimum wall thickness is 3.17 mm (1/8 ") for any area encapsulant.
Depending on the design and construction, whether or not the pillows are employed, some devices may require more or less hard compounds
General Recommendation:
Minimize the number of edges of pillow (no choice), intense edges by cushioning may cause micro-cracks in the encapsulant during the treatment process.
Remove sharp edges with curved insulation.
Recommended minimum wall thickness is 3.17 mm (1/8 ") for any area encapsulant.