04-08-2010, 05:36 PM
Home Automation Over Internet
This project comes into use in the situations like if you are not at home and
suddenly you reminded that you have left something on but you are not
sure and you can't even go back. With this, the fully automated home can be accessed from any part of the world over the internet. The main part of this project is the HOME AUTOMATION SERVER which enables the serial serial communication over TELNET which is a remote access utility. home appliances that are to be controlled are connected to the circuit. The embedded hardware
is then connected to your PC via serial communication running at 9600 8-n-1 configuration. Here, the . The HA server is running on the PC with any operating system and the system has a fixed IP address which is configured. on LAN then you can have a fix IP and in internet you must have a DNS. using the telnet command with the ip address of the server you have setup, you can connect to the server.
In the circuit diagram, various devices are connected through switches to different ports of the microcontroller. Different commands can be sent to control these. There is also an LCD display to display the status of the system.
The full details, circuit diagram and the source code can be downloaded from this link:
http://kmitl.ac.th/~kswichit%20/Ajay4/index.html
http://8051projectsdownloads16.html
This project comes into use in the situations like if you are not at home and
suddenly you reminded that you have left something on but you are not
sure and you can't even go back. With this, the fully automated home can be accessed from any part of the world over the internet. The main part of this project is the HOME AUTOMATION SERVER which enables the serial serial communication over TELNET which is a remote access utility. home appliances that are to be controlled are connected to the circuit. The embedded hardware
is then connected to your PC via serial communication running at 9600 8-n-1 configuration. Here, the . The HA server is running on the PC with any operating system and the system has a fixed IP address which is configured. on LAN then you can have a fix IP and in internet you must have a DNS. using the telnet command with the ip address of the server you have setup, you can connect to the server.
In the circuit diagram, various devices are connected through switches to different ports of the microcontroller. Different commands can be sent to control these. There is also an LCD display to display the status of the system.
The full details, circuit diagram and the source code can be downloaded from this link:
http://kmitl.ac.th/~kswichit%20/Ajay4/index.html
http://8051projectsdownloads16.html
