02-07-2016, 10:57 AM
please visit
Working Model of Transformer
INTRODUCTION
The transformer is a device used for converting a low alternating voltage to a high alternating voltage or a highalternating voltage into a low alternating voltage
PRINCIPLE
It is based on the principle of mutual induction that is if a varying current is set-up in a circuit induced e.m.f. isproduced in the neighboring circuit. The varying current in acircuit produce varying magnetic flux which induces e.m.f. inthe neighboring circuit
STEP-DOWN TRANSFORMER
In our project step-down transformer is used:This transformer converts high voltage atalternating current into low voltage alternating current. Instep-down transformer the number of turns in primary coilremains large as compare to secondary coil.
CONSTRUCTION
The transformer consists of two coils. They are insulated with each other by insulated material and wound on acommon core. For operation at low frequency, we may have asoft iron. The soft iron core is insulating by joining thin ironstrips coated with varnish to insulate them to reduce energy losses by eddy currents.The input circuit is called primary. And theoutput circuit is called secondary
Working Model of Transformer
INTRODUCTION
The transformer is a device used for converting a low alternating voltage to a high alternating voltage or a highalternating voltage into a low alternating voltage
PRINCIPLE
It is based on the principle of mutual induction that is if a varying current is set-up in a circuit induced e.m.f. isproduced in the neighboring circuit. The varying current in acircuit produce varying magnetic flux which induces e.m.f. inthe neighboring circuit
STEP-DOWN TRANSFORMER
In our project step-down transformer is used:This transformer converts high voltage atalternating current into low voltage alternating current. Instep-down transformer the number of turns in primary coilremains large as compare to secondary coil.
CONSTRUCTION
The transformer consists of two coils. They are insulated with each other by insulated material and wound on acommon core. For operation at low frequency, we may have asoft iron. The soft iron core is insulating by joining thin ironstrips coated with varnish to insulate them to reduce energy losses by eddy currents.The input circuit is called primary. And theoutput circuit is called secondary