selection of manufacturing method for knuckle joint pptet

[Guest]

I want to know manufacturing methods for knuckle joint

[jaseela123d]

A knuckle joint is a mechanical joint used to connect two rods that are under a tensile load, when there is a requirement for small amount of flexibility, or angular momentum is required. There is always an axial or linear load line.

The joint of the knuckles is a type of mechanical joint used in structures, to connect two cylindrical rods that cross, whose axes are in the same plane. It allows a certain angular movement between the cylindrical rods (in its plane). It is specially designed to withstand tensile loads.

Parts of a knuckle joint:

A typical joint joint has the following parts:

1. End of the fork

2. End of the eye

3. Pin

4. Collar

5. Conical bolt