fabrication of mini pneumatic vice in pdf

[Guest]

Please mail me PDF of pneumatic vice to ajmalhameed18.ahah[at]gmail.com

[seminar report asees]

fabrication of mini pneumatic vice in pdf

SYNOPSIS

In this project “FABRICATION OF PNEUMATIC VICE” we are using the pneumatic as pressing equipment; this will be useful in many applications. Like bending the metal rods, bearing fixing and pattern making etc… Compressor is need to give the pressure for ON pneumatic.Here we are using one key, which act as a control switch for pneumatic. Microcontroller always check the key whether it is pressed or not, if the key is pressed, it will give a low pulse to the controller. When the controller receives a low pulse from key, then it ON a pneumatic for gripping the object. When the key is pressed second time, the controller will off the pneumatic. So that the wise will release the object. This process will go repeatedly whenever the key is pressed. These are all done by microcontroller coding. Air compressor is used for ON/OFF the pneumatic, when the compressed air is passed to the pressure control valve; the required pressure is obtained by adjusting its knob. When the air is passed to the flow control valve, the speed of movement of piston (pneumatic) is controlled by adjusting the knob.

ADVANTAGES:

Ø It reduces the manual work.
Ø Less skilled operator is sufficient.
Ø Object does not drop from wise.
APPLICATIONS:

Ø Bearing press operation in all industries.
Ø Used for pattern making.
Ø Used in civil engineering for bending metal rods.