to construct a switch using a transistor project pdf
#1

[b] request about to construct a switch using a transistor project[/b]
Reply
#2

One of the most common uses for transistors in an electronic circuit is as simple switches. In summary, a transistor conducts the current through the collector-emitter path only when a voltage is applied to the base. When there is no base voltage present, the switch is off. When there is base voltage present, the switch is on.

In an ideal switch, the transistor must be in only one of two states: off or on. The transistor is off when there is no polarization voltage or when the bias voltage is less than 0.7 V. The switch is on when the base is saturated, so that the collector current can flow without restriction. This is a schematic diagram of a circuit that uses an NPN transistor as a switch that turns an LED on or off.

[Image: 308965.image0.jpg]

Look at this circuit component per component:
• LED: This is a standard red 5mm LED. This type of LED has a voltage drop of 1.8 V and is rated at a maximum current of 20 mA.
• R1: this resistance of 330 Ω limits the current through the LED to prevent the LED from being consumed. You can use Ohm's law to calculate the amount of current the resistor will allow it to flow. Because the supply voltage is +6 V, and the LED falls 1.8 V, the voltage at R1 will be 4.2 V (6 - 1.8). By dividing the voltage between the resistance, it obtains the current in amperes, approximately 0.0127 A. Multiply by 1,000 to obtain the current in mA: 12.7 mA, well below the 20 mA limit.
• Q1: this is a common NPN transistor. Here used a 2N2222A transistor, but almost any NPN transistor will work. R1 and LED are connected to the collector, and the transmitter is grounded. When the transistor is turned on, the current flows through the collector and the emitter, which illuminates the LED. When the transistor is off, the transistor acts as an isolator and the LED does not turn on.
• R2: This resistance of 1 kΩ limits the current flowing to the base of the transistor. You can use Ohm's law to calculate the current at the base. Because the base-emitter junction drops by about 0.7 V (same as a diode), the voltage across R2 is 5.3 V. The division 5.3 per 1,000 gives the current to 0.0053 A, or 5.3 mA. Therefore, the 12.7 mA (ICE) collector current is controlled by a base current of 5.3 mA (IBE).
• SW1: This switch controls whether current can flow to the base. Closing this switch turns the transistor on, which causes current to flow through the LED. Therefore, when closing this switch, the LED lights up even if the switch is not placed directly inside the LED circuit.

It can be understood in the following video:
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: to construct a switch using a transistor project, project on transistor as a switch pdf, to construct a switch using a transistor and to draw the graph between input and output voltage and mark the cut off saturati, to construct a switch using a transistor and to draw the graph between the input and output voltage and mark the cut off satu, free download project to construct a switch using a transister, how to construct a switch using a transistor and to draw the graph between the input and output voltage and mark the cut off3, to construct a switch using a transistor and to draw the graph between the input and out put voltages and mark the cut off sa,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  I need this pdf for my project 0 1,527 31-03-2021, 01:42 PM
Last Post:
  Project on plastic money in Marathi pdf... 0 3,855 31-05-2020, 03:29 PM
Last Post:
  class 12 business studies project on marketing management pdf on mobile phones 3 3,604 20-12-2018, 12:16 AM
Last Post:
  fire alarm project for class xii pdf 0 1,193 31-10-2018, 08:37 PM
Last Post: Guest
  to construct a switch using a transistor project pdf 0 831 27-10-2018, 11:07 PM
Last Post: Guest
  project on marketing management for class 12 on chocolate pdf 0 1,066 26-10-2018, 09:24 PM
Last Post: Guest
  bus ticket reservation project pdf 0 1,464 23-10-2018, 10:01 PM
Last Post: Guest
  project on communication system class 12 pdf 0 1,693 20-10-2018, 06:36 PM
Last Post: Guest
  beam engine mini project report file download pdf 0 11,018 14-10-2018, 09:03 PM
Last Post: Guest
  project on marketing management for class 12 on chocolate pdf 0 775 08-10-2018, 07:35 PM
Last Post: Guest

Forum Jump: