project report on battery level indicator pdf
#1

Hi am Meenakshii would like to get details on project report on battery level indicator pdf ..My friend Justin said project report on battery level indicator pdf will be available here and now i am living at ......... and i last studied in the college/school ......... and now am doing ....i need help on ......etc
Reply
#2
i need the project urgently.........i have been given this project 4 my respective semester.....i hope u will send it soon as soon as possible........if i will get the report  i will always remember this helpful site
Reply
#3

Normally in mobile phones the battery level is shown as a point or bar. This allows you to easily recognize the battery level. Here we present a battery level indicator circuit that allows you to know the battery level of a device based on the amount of LEDs that are shining. It uses ten LEDs in total. Then if three LEDs shine, it indicates a battery capacity of 30 percent.

[Image: Battery-level-Indicator-1.jpg]


Unlike mobile phones, in which the function of the battery level indicator is integrated with other functions, here only a comparison IC (LM3914) does it all. The LM3914 uses ten comparators, which are assembled internally in the voltage divider network according to the current division rule. Therefore, divide the battery level into ten parts.

Battery level indicator circuit

The circuit derives the power supply for its operation from the device's battery. It uses ten LEDs connected in a 10-point mode. The use of different colored LEDs makes it easier to recognize the voltage level depending on the calibration performed. The red LEDs (LED1 to LED3) indicate a battery capacity of less than 40 percent.

Orange LEDs (LED4 to LED6) indicate a battery capacity of 40 to less than 70% and green LEDs (LED7 to LED10) indicate a battery capacity of 70 to less than 100%. The brightness of the LEDs can be adjusted by varying the value of the preset VR2 between pins 6 and 7.

[Image: 768_dec_1_efy.jpg]

Diode D1 prevents the circuit from connecting the battery with reverse polarity. The tenth LED lights up only when the capacity of the battery is full, ie the battery is fully charged. When the battery is fully charged, the relay controller transistor T1 leads to energize the relay RL1. This stops charging through normally open contacts (N / O) of relay RL1.

For calibration, connect the regulated and variable 15V power supply and set it initially to 3V. Slowly adjust VR1 until LED1 lights up. Now, increase the input voltage to 15V in steps of 1.

2 V until the corresponding LED lights up (LED2 to LED10).

Now the circuit is ready to show any voltage value with respect to the maximum voltage. Since the number of LEDs is ten, we can easily consider an LED for 10 percent of the maximum voltage.
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: mini project battery level indicator, project report of battery level indicator, battery level indicator project documentation, battery level indicator mini project free pdf downloads, battery level monitor seminar and pdf, battery level indicator project report, electronics for you battery level indicator project report,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  Over Speed Alarm Indicators of Electrical Motor with Digital RPM Indicator 0 250 25-07-2023, 05:33 AM
Last Post:
  I need this pdf for my project 0 1,509 31-03-2021, 01:42 PM
Last Post:
  project report 0 3,766 12-09-2020, 07:27 PM
Last Post:
  Project on plastic money in Marathi pdf... 0 3,709 31-05-2020, 03:29 PM
Last Post:
  Report in PDF format 0 7,307 18-05-2020, 11:28 AM
Last Post:
  Multi purpose machine project report 0 2,103 20-02-2019, 10:23 AM
Last Post:
  class 12 business studies project on marketing management pdf on mobile phones 3 3,565 20-12-2018, 12:16 AM
Last Post:
  civil engineering extensive survey project report 0 2,230 03-11-2018, 11:26 PM
Last Post: Guest
  fire alarm project for class xii pdf 0 1,180 31-10-2018, 08:37 PM
Last Post: Guest
  to construct a switch using a transistor project pdf 0 825 27-10-2018, 11:07 PM
Last Post: Guest

Forum Jump: