HI, I AM MBUOTIDEM UDO, I,M CONDUCTING A RESEARCH ON POWER GRID CONTROL THROUGH PC SO I NEED YOUR ASSISTANCE ON ANY AVAILABLE INFO ON THE TOPIC.
THANKS

Power grid control via PC

The main purpose of this project is to control Transformers on PC Hyper through PC The person sitting in front of the terminal window PC can constantly check status Transformer is being operated in the room and can stop them whenever it is not necessary. Sitting in front of your PC. Transformers are controlled by TRIAC. Main The advantage of using TRICAC to change the load position is that the TRAC has reduced the energy flow Loads and TRACs work very well for direct currents. To control the transformer through the PC, the data transfer between the PC should be ensured 8051 system serial data communication uses a data line which makes it not cheap But also enables two computers located in two different cities to communicate Phone. There are special IC chips created by many manufacturers for serial data Communications. These chips are commonly known as USART (Universal Synchonsynchronous) Receiver transmitter) and UART (Universal Asynchronous Receiver Transmitter). The 8051 chip has a built-in UART, which has an integrated serial port that enables one to read And write the value of the serial port very easily Data transfer rate in serial data communication is described in BPS (bits per second) or in baud do the Evolution. To allow data transfer without any error between PC and 8051 system, the rate of baud The 8051 system must match the baud rate of the PC port of the com port. Thus operation mode and The baud rate of the serial port is to be configured. Once configured, read or write operations can be Display accordingly Thus, the status of the transformer can be different just before sitting on the PC. The commands The access control unit is passed through the PC keyboard. Thus, on the basis of order Received, microcontroller operates a special transformer based on user requirement.