Internal combustion engines for the future
#1

ABSTRACT
Future internal combustion engines for light duty applications will have to cope with a very complex set of customer, legal and business requirements. durability, reliability, drivability, fuel economy, and cost of ownership etc are the digfferent area where the customers would like improvements. DIesel engines will have to cater to future emission standards at affordable cost. airhandling/boosting and control system are the focus areas. fuel economy improvements through improved combustion
systems will be the focus for petrol engines. high power density, low manufacturing cost, recyclability etc should be maintained while reducing the emissions.

THE DIESEL EMISSIONS CHALLENGE
These kind of engiens must cop up with future emission targets at affordable cost. Euro Stage 4 standard must be met the next year itself. NOx and particulate matter (PM) standards must be particularly focussed while keeping an eye on CO and HC too.

LOW NOx DIESEL COMBUSTION

HCCI, pHCCI, UNIBUS, PREDIC, MK, NADI, ACCP, HCLI, HCDC etc are the various low NOx diesel combustion processes. These are low temperature combustion (LTC) processes and they have high EGR rates so that bulk temperature of the cylinder charge can be limited. a boosting/airhandling/ EGR system that effectively provides the right mixture out of boost pressure and EGR rate under all load and speed
conditions is an essential component for maintaining low temperature combustion.

Diesel exhaust after treatment

Lean NOx traps and selective catalytic reduction must be focussed upon. However the SCR has the most potential as it has a higher NOx reduction potential because of its
wider temperature window with high conversion rates

Full report:
[attachment=4358]







Reply
#2
[attachment=14972]
This paper presents the essential design features of the spark ignition (SI), piston-cylinder engine. Referring to Figure 1 :
S - Stroke
s - Distance between crank and
wrist pin axes
 - Crank angle
B - Bore
r – Connecting rod
a – Crankshaft offset
Vc – Clearance volume
Vd – Displacement volume
TDC – Top dead center
BDC – Bottom dead center Figure 1: Piston and Cylinder Geometry of Reciprocating Engine
Definitions
Top Dead Center (TDC) - Maximum travel of piston toward cylinder head. The cylinder volume at TDC is called the clearance volume.
Bottom Dead Center (BDC) - Minimum travel of piston toward crankshaft.
bore (B) - Cylinder diameter (piston diameter = cylinder diameter - clearance).
Stroke (S) - Distance between TDC and BDC.
Displacement (Vd) - volume of cylinder between TDC and BDC.
The Four-Stroke, Air Standard Ideal Otto Cycle
Referring to Figure 2 :
First stroke, Process 6-1 (Induction).
The piston travels from TDC to BDC with the intake valve open and the exhaust valve closed (some valve overlap occurs near the ends of strokes to accommodate the finite time required for valve operation). The temperature of the incoming air is increased 25-35 C over the surrounding air as the air passes through the hot intake manifold.
Second Stroke, Process 1-2 (Compression).
At BDC the intake valve closes. The piston travels to TDC compressing the cylinder contents at constant entropy. Just before TDC, the spark plug fires initiating combustion.
Combustion, Process 2-3.
This process is modeled at constant volume even though combustion requires a finite time in a real engine (cylinder is moving). Peak cycle temperature and pressure occur at state 3.
Third Stroke, Process 3-4 (Expansion or power stroke).
With all valves closed, the piston travels from TDC to BDC. The process is modeled at constant entropy.
Exhaust Blowdown, Process 4-5.
Near the end of the power stroke, the exhaust valve is opened. The resulting pressure differential forces cylinder gases out dropping the pressure to that of the exhaust manifold. The process is modeled at constant volume.
Figure 2: Ideal air-Standard Otto Cycle
Fourth Stroke, Process 5-6.
With the exhaust valve open, the piston travels from BDC to TDC expelling most of the remaining exhaust gases.
Note: The four strokes require two complete revolutions of the crankshaft.
Reply
#3

to get information about the topic "internal combustion engine " full report ppt and related topic refer the page link bellow


http://studentbank.in/report-hydrogen-us...on-engines

http://studentbank.in/report-classificat...on-engines

http://studentbank.in/report-internal-co...e=threaded

http://studentbank.in/report-internal-co...the-future

http://studentbank.in/report-emission-co...e=threaded

http://studentbank.in/report-egr-system-...g-the-same

http://studentbank.in/report-internal-co...e=threaded

http://studentbank.in/report-internal-co...-ic-engine


http://studentbank.in/report-internal-co...e=threaded
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: internal combustion engines, advanced hydrogen fueled internal combustion engines ppt, internal combustion engines book, alternative fuels hydrogen in internal combustion engines, internal combustion engines applied thermosciences, combustion engines, combustion in si engines ppt,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  free download internal combustion engine by mathur sharma pdf 3 9,457 26-12-2017, 10:41 AM
Last Post: jaseela123d
  student database management with attendance and internal marks 3 1,352 18-09-2017, 11:43 AM
Last Post: jaseela123d
  Money Pad, The Future Wallet sunit 15 7,646 15-02-2017, 03:28 PM
Last Post: jaseela123d
  Money pad the future wallet Mitkari Yogita 10 8,193 22-10-2016, 09:59 AM
Last Post: anusree
  internal circuit diagram of grinder and mixer 1 933 20-07-2016, 04:11 PM
Last Post: dhanabhagya
Wink multimedia looking towards future digital communication pdf 2 798 14-07-2016, 09:14 AM
Last Post: jaseela123d
  physics investigatory to study various factors on which the internal resistance emf of a cell depends 1 1,421 05-07-2016, 12:02 PM
Last Post: visalakshik
  to study various factors on which internal resistance emf of a cell depends 1 618 23-06-2016, 03:03 PM
Last Post: seminar report asees
  future enhancement to online doctor appointment mini project 1 800 23-06-2016, 02:59 PM
Last Post: seminar report asees
  future scope of modified booth multiplier 1 689 03-06-2016, 04:29 PM
Last Post: dhanabhagya

Forum Jump: