Induction motors vector control Drive using sliding mode flux observer full report
#1

[attachment=2702]
Abstract:
The field oriented control emerged as an important approach for the control of AC machines, and continues to be explored and developed in the literature. The estimation of the rotor flux from the measurable variables was the only method used to implement the vector control of the induction machine. To replace the estimator based on the mathematical model of the system, which can lead to unintended errors due to uncertainties on the model and on the measures we use an appropriate observer.

Presented By:
Cherif Mokhtar, Azzedine Bendiabdellah, Abdelkader Mezouar and Ameur Fethi Aimer
Department of Electrical Engineering, University of Science and Technology Oran, Algeria.
INTRODUCTION
field orientation technique namely the Rotor flux orientation introduced by BLASCHKE in 1972, has made it possible to act independently on the rotor flux and the electromagnetic torque which gives us an induction machine as good in the areas of variable speed drive as a DC machine, but the aimed decoupling can not be insured in steady states when the rotor flux amplitude is kept constant, which presents a serious constraint especially for rotating machines at high speeds ( higher than the nominal speed) [1]. A Nonlinear control is often necessary for best performance. The sliding mode control is a technique that works as well with the linear systems as with nonlinear systems. This technique has two stages: Forcing the variable control of the system to reach an hyper-surface as quickly as possible, then slides until it reaches a certain point, during its second phase, the system is in a sliding state and its dynamic behaviour is independent of system parameters, as well as disturbances, and therefore insensitive to parameter variations. Whatever the technique used (classical or sliding mode control) knowledge of the values of state variables is required. The use of sensors causes the congestion of the installation and creates fragility and disability of precision. Faced with these problems, we use a sliding mode observer.
Reply

Important Note..!

If you are not satisfied with above reply ,..Please

ASK HERE

So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Popular Searches: sliding mode control pptting interview questions in bsnl, multi bandhysteresis modulation and switching characterziationfor sliding mode controlled cascade multilevel inverter, sliding mesh gearbox seminar pdf, rf control of induction motors and other industrial loads, kalman filter as state observer of induction motor, fault detection and protection of induction motors using plc, thrust vector control ppt,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  Space Vector Pulse Width Modulation (SVPWM) Scheme for Inverter Using MATLAB/SIMULINK project report helper 11 10,289 25-05-2016, 01:38 AM
Last Post: Guest
  DC MOTOR CONTROL USING CHOPPER seminar class 3 5,720 25-11-2015, 02:00 PM
Last Post: seminar report asees
  A Neural-Network-Based Space-Vector PWM Controller for Voltage-Fed Inverter Inducti project report helper 1 8,846 07-09-2015, 06:23 PM
Last Post: hafsa_012
  man made sun full report seminar presentation 2 3,407 26-12-2014, 05:39 AM
Last Post: Guest
  microprocessor based system of automatic synchronizer full report computer science technology 10 8,521 05-09-2014, 10:44 PM
Last Post: seminar report asees
  artificial intelligence techniques in power systems full report computer science technology 3 5,684 08-08-2014, 10:39 PM
Last Post: seminar report asees
  thermoelectric power generation full report project report tiger 8 8,172 07-03-2014, 07:43 PM
Last Post: Guest
  powerline communication full report computer science technology 15 16,784 02-09-2013, 11:28 AM
Last Post: computer topic
  gas insulated substation full report project report tiger 14 37,139 06-08-2013, 01:14 PM
Last Post: Guest
  High Performance Motor Drive Using Matrix Converter project topics 3 9,387 27-07-2013, 10:35 AM
Last Post: computer topic

Forum Jump: