05-03-2011, 01:06 PM
PRESENTED By:
DHARMENDRA SINGH
KAMAL RAJ SINGH
[attachment=9593]
IMPLEMENTATION OF MOBILE PHONE
1. Introduction:-
In this communication project we are designing codes for GSM
for attending the call
for making the call
for accessing the phone book
for sending the SMS
In this project we are designing the code in ‘C’ for above three applications. Then by using KEIL software we are converting these ‘C’ codes in hex file. After converting we burn this hex code in 8051 microcontroller kit with the help of FLASH MAGIC software and then with the help GSM modem we do these operations.
2.Equipments used and their description:-
Equipments used:-
In this project we are using these equipments
A personel computer
8051 microcontroller kit
GSM modem kit
SIM card (suscribers identification module)
Software used :-
We are using
KEIL software for converting the ‘C’ code in hex code
FLASH MAGIC for burning this hex code in 8051 microcontroller
Description :-
8051 microcontroller kit:-
It provides many functions (CPU, RAM, ROM, I/O, interrupt logic, timer, etc.) in a single package
8-bit ALU, Accumulator and 8-bit Registers; hence it is an 8-bit microcontroller
8-bit data bus - It can access 8 bits of data in one operation
16-bit address bus - It can access 216 memory locations - 64 KB (65536 locations) each of RAM and ROM
On-chip RAM - 128 bytes (data memory)
On-chip ROM - 4 kByte (program memory)
Four byte bi-directional input/output port
UART (serial port)
Two 16-bit Counter/timers
Two-level interrupt priority
Power saving mode
GSM modem kit:-