hi sir can u please post the gas leakage alarm ppt using mq-6 sensor in detail i mean without using the MC plz

mzLnm
please send ppt of gas leekage alarm

plz send ppt to my mail ------------------- lkg449[at]gmail.com

gas leakage alarm ppt

LPG gas is supplied in pressurized steel cylinders. As this gas is heavier than air, when it leaks from a cylinder it flows along floor and tends to settle in low spots such as a basement. This can cause fire or suffocation if not dealt with. Here is a circuit that detects the leakage of LPG gas and alerts the user through audio-visual indications.This LPG Gas Sensor (MQ6), ideal sensor for use to detect the presence of a dangerous Liquefied petroleum gas (LPG) and it has high sensitivity to propane, butane, isobutene, natural gas. The sensor can also be used to detect combustible gases, especially methane. This circuit can detect leakages in your Home, car or in a service station, storage tank environment. This unit can be easily implemented to industrial level by upgrading its ranges.This project is designed to detect the LPG from 200parts per million (PPM) to 10,000 PPM. Whenever there is LPG concentration of 1000 ppm (parts per million) in the area, the OUT pin of the sensor module goes high. This signal drives timer IC 555, which is wired as an astable multivibrator. The multivibrator basically works as a tone generator. A buzzer is connected to produce audible alert signal.This LPG Gas Sensor can be used to make wireless Gas leak detector in home security system .The LPG Gas Sensor Module is designed to enable LPG detection interface to Microcontroller without ADC Channels. By providing a GSM modem we can receive “SMS ALERTS” also.MQ 6 Gas sensor is used as LPG, Butane and Propane Sensor to generate alarm when there is leakage of these gases from the source. MQ6 is a highly sensitive gas sensor to petroleum based gases but less sensitive to Alcohol and Carbon di oxide. This simple sensor can be installed in the kitchen to give warning alarm if there is leakage of LPG.MQ6 gas sensor is a 6 pin device and it requires 5 volt DC maximum which is derived from a Zener based power supply. There is a heating element inside the sensor which becomes hot at 5 volt and remains stand by. When the sensor detects gas molecules between 100 ppm to 1000 ppm, in the atmosphere, its output turns high and triggers T1 to activate the buzzer. Red LED indicates the high output from the sensor.