Battery charger circuit using SCR.


  Battery charger circuit.pdf (Size: 280.06 KB / Downloads: 6)
Description.

A simple battery charger based on SCR is shown here.Here the SCR rectifies the AC mains voltage to
charge the battery.When the battery connected to the charger gets discharged the battery voltage
gets dropped.This inhibits the forward biasing voltage from reaching the base of the transistor Q1
through R4 and D2.This switches off the transistor.When the transistor is turned OFF,the gate of
SCR (H1) gets the triggering voltage via R1 & D3.This makes the SCR to conduct and it starts to
rectify the AC input voltage.The rectified voltage is given to the battery through the resistor
R6(5W).This starts charging of the battery.
When the battery is completely charged the base of Q1 gets the forward bias signal through the
voltage divider circuit made of R3,R4,R5 and D2.This turns the transistor ON.When the Q1 is turned
ON the trigger voltage at the gate of SCR is cut off and the SCR is turned OFF.In this condition a
very small amount of charge reaches the battery via R2 and D4 for trickle charging.Since the
charging voltage is only half wave rectified ,this type of charger is suitable only for slow charging.For
fast charging full wave rectified charging voltage is needed.