Posts: 3,561
Threads: 923
Joined: Sep 2010
[attachment=8370]
BY RAVINDRA REDDY N
INTRODUCTION
The fourth state of matter, now called plasma .
Conductive assemblies of charged and neutral particles.
Carry electrical currents and generate magnetic fields.
In antenna’s the conducting element (metal) is replaced by plasma
Plasma elements can be energized and de–energized in seconds.
Hence prevents signal degradation.
Types ex: dipole antenna, a loop antenna and reflector antennas.
OVERVIEW ON PLASMA ATENNA TECHNOLOGY
Antenna design has been an integral part of virtually every communication and radar application
Antenna represents a conducting metal surface that is sized to emit radiation at one or more selected frequencies
Employs ionized gas enclosed in a tube
Employs solid metal wires as the conducting element
"ringing" and associated effects of solid wire antenna design are eliminated
When gas is charged, it becomes conductive, allowing radio frequency (RF) signals to be transmitted or received
performance is equal to a copper wire antenna in every respect.
It can be used over a large frequency range up to 20GHz
Can employ a wide variety of gases
TYPES OF PLASMA ANTENNAS
1: Helical plasma antenna
2:Spiral plasma antenna
3: Planer array plasma antenna
MARKET APPLICATIONS OF PLASMA TECHNOLOGY
Antenna and Transmission Line Applications
Plasma Mirrors (Reflectors) and Lenses
Potential military applications include:
Shipboard/submarine antenna replacements.
Unmanned air vehicle sensor antennas.
IFF ("identification friend or foe") land-based vehicle antennas.
Stealth aircraft antenna replacements.
Broad band jamming equipment including for spread-spectrum emitters.
ECM (electronic counter-measure) antennas.
Phased array element replacements.
EMI/ECI mitigation
Detection and tracking of ballistic missiles
Side and back lobe reduction
commercial applications in telemetry, broad-band communications, ground penetrating radar, navigation, weather radar, wind shear detection and collision avoidance, high-speed data (for example Internet) communication spread spectrum communication, and cellular radiation protection.
Microwave Devices:
Filters and Phase Shifters
Microwave Tubes
microwave band pass filter
The input signal is dissipated in the load, or reflective, allowing the input signal to return to the circulator and exit the device.
By changing the plasma parameters the pass band of the filter can be modified.
multiple plasma columns could be inserted
Variable time delay can be obtained by switching in different numbers of segments between the plasma columns
Microwave Tubes
The presence of a controlled amount of plasma in traveling-wave tubes and backward-wave oscillators can lead to improvement in their operating characteristics above those of evacuated devices. Specifically, the bandwidth and power handling capability can be increased
UNIQUE CHARACTERISTICS OF PLASMA ANTENNA
The gas ionizing process can manipulate resistance
After sending a pulse the plasma antenna can be de-ionized, eliminating the ringing associated with traditional metal elements.
When de-ionized, the gas has infinite resistance and does not interact with RF radiation.
When de-ionized the gas antenna will not backscatter radar waves (providing stealth) and will not absorb high-power microwave radiation (reducing the effect of electronic warfare countermeasures).
It provides increased accuracy and reduces computer signal processing requirements.
These advantages are important in cutting edge applications for impulse radar and high-speed digital communications.
Based on the results of development to date, plasma antenna technology has the following additional attributes
No antenna ringing provides an improved signal to noise ratio and reduces multipath signal distortion.
Reduced radar cross section provides stealth due to the non-metallic elements.
Changes in the ion density can result in instantaneous changes in bandwidth over wide dynamic changes.
After the gas is ionized, the plasma antenna has virtually no noise floor
A circular scan can be performed electronically with no moving parts at a higher speed than traditional mechanical antenna structures.
It has been mathematically illustrated that by selecting the gases and changing ion density that the electrical aperture (or apparent footprint) of a plasma antenna can be made to perform on par with a metal counterpart having a larger physical size.
low ionization level can be decoupled from an adjacent high-frequency transmitter
Can transmit and receive from the same aperture provided the frequencies are widely separated.
Plasma resonance, impedance and electron charge density are all dynamically reconfigurable.
A single dynamic antenna structure can use time multiplexing
Hence many RF subsystems can share one antenna resource reducing the number and size of antenna structures
SPONSORED WORK
plasma antenna technology has been studied and characterized by ASI Technology Corporation
The work was carried out in part through two ONR sponsored contracts
NCCOSC RDTE Division, San Diego, awarded contract N66001-97-M-1153 1 May 1997.
The major objective of the program was to determine the noise levels associated with the use of gas plasma as a conductor for a transmitting and receiving antenna.
The second contract N00014-98- C-0045 was a 6-month SBIR awarded by ONR on November 15, 1997
The major objective of this effort was to characterize the GP antenna for conductivity, ionization breakdowns, upper frequency limits, excitation and relaxation times, ignition mechanisms, temperatures and thermionic noise emissions and compare these results to a reference folded copper wire monopole.
ASI Technology Corporation is under contract with General Dynamics Electric Boat Division and in conjunction with the Plasma Physics Laboratory at the University of Tennessee, an inflatable plasma antenna is being developed.
This antenna is designed to operate at 2.4 GHz and would be mounted on the mast of an attack submarine.
In addition a prototype plasma waveguide and plasma reflector has been designed and demonstrated to General Dynamics.
TECHNOLOGICAL CONCEPTS OF PLASMA ANTENNAS
Higher Power
Enhanced Bandwidth
EMI/ECI
Higher Efficiency and Gain
Reconfiguration and Multi functionality
Lower Noise
Perfect Reflector
ADVANTAGES
Reduced RCS
Reduced interference and ringing
Change shape to control patternand bandwidth
Change plasma parameters
Glow discharge increases
visible signature *
Good RF coupling for electrically small antennas
Frequency selectivity
Stable and repeatable
Efficient
Flexibility in length and direction of path
DISADVANTAGES
Ionization and decay times limit
Scanning
Plasma volumes must be stable
and repeatable
Ionizer adds weight and volume
Ionizer increases power Consumption
Not durable or flexible
Higher ionization energy than
for a tube
CONCLUSION
As part of a “blue skies” research program, DSTO has teamed up with the ANU’s Plasma Research Laboratory to investigate the possibility of using plasmas like those generated in fluorescent ceiling lights, for antennas
The fact that metal structures cannot be easily moved when not in use limits in some aspects of antenna array design.
It can also pose problems when there is a requirement to locate many antennas in a confined area
Weapons System Division has been studying the concept of using plasma columns for antennas, and has begun working in collaboration with ANU.
The type of plasma antenna under investigation is constructed using a hollow glass column which is filled with an inert gas
The metal whips that may be considered for a plasma replacement are anywhere from a few centimeters to several meters long.
DSTO and ANU are now investigating the commercialization of the technology.
Plasma antenna technology offers the possibility of building completely novel antenna arrays, as well as radiation pattern control and lobe steering mechanisms that have not been possible before.
The research may one day have far reaching applications from robust military antennas through to greatly improve external television aerials
To date, the research has produced many novel antennas using standard fluorescent tubes and these have been characterized and compare favorably with their metal equivalents..
For example, a 160 MHz communications page link was demonstrated using plasma antennas for both base and mobile stations.
Current research is working towards a robust plasma antenna for field demonstration to Defense Force personnel
REFERENCES & BIBILOGRAPHY
J Drummond, Plasma Physics, McGraw-Hill.
M. Heald and C. Warton, Plasma Diagnostics with Microwaves, Krieger Publishing Co.
ASI Technology Corporation web page: http://asiplasma
W. Manheimer, “Plasma Reflectors for Electronic Beam Steering in Radar Systems,”
IEEE Transactions on Plasma Science.
1. J. Hettinger, “Aerial Conductor for Wireless Signaling and Other Purposes,” Patent
number 1,309,031, July 8, 1919.22
2. V. L. Ginzburg, The Propagation of Electromagnetic Waves in Plasmas, Pergamon
Press,1970.
3. J. Drummond, Plasma Physics, McGraw-Hill, 1961.
4. M. Heald and C. Warton, Plasma Diagnostics with Microwaves, Krieger Publishing Co.,
1978.
5. U. Inan and A. Inan, Electromagnetic Waves, Prentice-Hall, 2000.