Respected sir i am student of mtech i need seminar report on ac by waste heat of car. ....etc

[:=Read Full Message Here=:]

Submitted By:
SAMBIT SWARUP SATPATHY
ABHIJIT MISHRA
ARUN KUMAR
PUNIT KAR
RAKESH MISHRA
ABINASH MAHANTA
ASHIS NAIK
VIVEK KUMAR UPADHYAYA
ANIL KUMAR SAMAL
ABHISHEK KHANDELWAL


ABSTRACT
The amateur work of us tries to bring a joint unit of air and water
cooler un ....etc

[:=Read Full Message Here=:]

Sir.. When i visited this site i have got a seminar topic Automobile AC BY WASTE HEAT AND GAS.. And i submitted that in our college as a final year mechanical seminars.. So i would like to get report on that topic.. Please. Bye Rauf.. ....etc

[:=Read Full Message Here=:]

DEVELOPMENT OF AN A/C SYSTEM USING WASTE
HEAT OF AN IC ENGINE
ABSTRACT
The refrigerating units currently used in road transport vehicle are of Vapour Compression Refrigeration system (VCRS). This system utilizes power from the engine shaft as the input power to drive the compressor of the refrigeration system, hence the engine has to produce extra work to run the compressor of the refrigerating unit utilizing extra amount of fuel. This loss of power of the vehicle for refrigeration can be neglected by utilizing another r ....etc

[:=Read Full Message Here=:]

Submitted by,
Aniket Nemade


Less Emission through Waste Heat Recovery
Introduction – Why waste heat recovery?
Reducing emissions and reducing engine operating costs
To increase exhaust gas energy and employing both steam and exhaust gas turbines in a Total Heat Recover Plant
low-speed marine engines are very highly developed and there is little potential for achieving significant reductions in CO2 emissions
Controlling the generation of the emissions inside engine cylinders,
Removi ....etc

[:=Read Full Message Here=:]

Presented by:
A.JohnBritto
C.Kanaga Raj
P.Senna Kesavan
A.VinothHEAT TRANSFER PERFORMANCE IN 3D INDUCED FINNED HEAT PIPE

ABSTRACT
3D induced finned steel-water heat pipe is carried out in this project.

All the main parameters that can significantly influence the heat transfer performance of heat pipe ,such as working temperature, heat flux, inclination angle, working fluid fill ratio (defined by the evaporatio ....etc

[:=Read Full Message Here=:]

Jet impingement heat transfer – Part I: Mean and root-mean-square heat transfer and velocity distributions
Abstract
Impinging jets provide a means of achieving high heat transfer coefficients both locally and on an area averaged basis. The currentwork forms the first stage of a two part investigation of heat transfer distributions from a heated flat surface subject to an impinging airjet for Reynolds numbers from 10,000 to 30,000 and non-dimensional surface to jet exit spacing, H/D, from 0.5 to 8. In the present paper,the rel ....etc

[:=Read Full Message Here=:]

High Conductance Heat Transfer Using Solar Heat Pipe Collector

presented by :-
MR. SHIVAJI D. YADAO1, MR. PRMENDRA J BANSOD2
Dr. D.Y.Patil Institute of Engg. & Tech.,Pune University, Pune,
Dr. D.Y.Patil Institute of Engg. & Tech.,Pune University, Pune,

abstract
In recent years it has become increasingly important to develop methods for efficient transport of thermal energy from one location to another. Moreover the advent of the space age has stimulated research for heat transfer devices which are ....etc

[:=Read Full Message Here=:]

DjtmtjapjmTjdgumjpxjgugumjpupvdmtpgmtpglngjmtpgajptnjgtwjpuwdjgpm ....etc

[:=Read Full Message Here=:]

K. Wojciechowski, J. Merkisz, P. Fuć
, P. Lijewski, M.Schmidt


Abstract
Automotive engines reject a considerable amount of energy to the ambience through the exhaust gas. Significant reduction of engine fuel consumption could be attained by recovering of exhaust heat by using thermoelectric generators. One of the most important issues is to develop an efficient heat exchanger which provides optimal recovery of heat from exhaust gases. The work presents a design and perform ....etc

[:=Read Full Message Here=:]