Concrete is an indispensable construction material of modern age. The properties of concrete are greatly dependant on the constituents, workmanship, water-cement ratio, compaction, curing etc. Direct assessment of the strength of concrete is not possible because direct tests induces destructive stresses and causes failure of the structure. So the concrete strength is tested using standard specimens made with the same mix as that of the structure. But the test specimens can vary from the actual structure in properties due to difference in compac ....etc

[:=Read Full Message Here=:]

A Project Report on
Simulation Testbed for Evaluation of
Critical Software in Launch Sequence
Submitted in Partial fulfillment of the requirements for the award of
the degree of
Master of Technology
In
Software Engineering
Submitted by
Sreebal I S
Under the Esteemed Guidance of
Mr. Santhosh Kumar G
Lecturer
Dept. of Computer Science, CUSAT
DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND TECHNOLOGY,
KOCHI-682022, KERALA
JUNE 2008Page 2
Page 3

DEPARTMENT OF COMPUTER SCIENCE,
COCHIN UNIVERSITY OF SCIENCE AND ....etc

[:=Read Full Message Here=:]

Explain the conflicts in this novel that arise from issues concerning multiple culture conflicts and coming of age? ....etc

[:=Read Full Message Here=:]

SEMINAR REPORT ON EVALUATION OF FLOW LIQUEFACTION AND LIQUEFIED SHEAR STRENGTH USING CONE PENETRATION TEST


ABSTRACT

Flow liquefaction is a major design issue for large soil structures such as mine tailings impoundments and earth dams. If a soil is strain softening in undrained shear and, hence, susceptible to flow liquefaction, an estimate of the resulting liquefied shear strength is required for stability analyses. Many procedures have been published for estimating the residual or liquefie ....etc

[:=Read Full Message Here=:]

Concrete is an indispensable construction material of modern age. The properties of concrete are greatly dependant on the constituents, workmanship, water-cement ratio, compaction, curing etc. Direct assessment of the strength of concrete is not possible because direct tests induces destructive stresses and causes failure of the structure. So the concrete strength is tested using standard specimens made with the same mix as that of the structure. But the test specimens can vary from the actual structure in properties due to difference in compac ....etc

[:=Read Full Message Here=:]

Definition
This paper addresses the issue of exam paper evaluation using neural network. This paper foresees the possibility of using adaptive real time learning through computers viz. the student is made to feed his answers in a restricted format to the computer to the questions it puts up and the answers are evaluated instantaneously. This is accomplished by connecting the computers to a Knowledge Server. This server has actually connections to various authenticated servers (encyclopedias) that contain valid information about all the subject ....etc

[:=Read Full Message Here=:]

Evaluation of the Power Consumption of
Routing Protocols
for
Wireless Sensor Networks
# G. Santhosh
Kumar*
, Lino Abraham Varghese ,
Jose
Mathew
K
and
K.
Poulose
Jacob*
Department of Computer Science,
Cochin
University of Science
and
Technology
Cochin, Kerala, INDIA, *{san, kpj}@cusat.ac.in
Abstract
implosion problem experienced by Flooding
as
only
one copy
Sensor
networks
are one
ofthefastest growing
areas in
broad of
a
packet
is in transit
at
any
one
time.
In
GBR, each node in the network
can
look
at ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]

Titanium matrix composites (TMCs) have been extensively evaluated for their potential to replace conventional superalloys in high temperature structural applications, as they provide significant weight-savings while maintaining comparable mechanical properties. Gamma titanium aluminide alloys and an appropriate fiber could offer an improved TMC for use in intermediate temperature applications (400-800°C). The purpose of this investigation is aimed at evaluating the potential of a gamma titanium aluminide alloy with nominal co ....etc

[:=Read Full Message Here=:]

Embedded systems are computing devices that are radically different from normal desktop computers in terms of the specific requirements of the application for which they are used. Characteristics such as reactivity, robustness, power, size and cost issues force certain design constraints which are otherwise obviated or trivial. Traditional computer design methodologies do not fully address essential design issues critical to system requirements. Certain issues peculiar to embedded systems have been identified and a few possible guidelines to r ....etc

[:=Read Full Message Here=:]