Low voltage differential signaling, or LVDS, is an electrical signaling system that can run at very high speeds over cheap, twisted-pair copper cables. It was introduced in 1994, and has since become very popular in computers, where it forms part of very high-speed networks and computer buses.
LVDS uses the difference in voltage between two wires to signal information. The transmitter injects a small current, nominally 3.5 milliamperes, into one wire or the other, depending on the logic level to be sent. The current passes through a resistor o ....etc

[:=Read Full Message Here=:]

Low-Voltage Differential Signaling (LVDS) is a new technology addressing the needs of today's high performance data transmission applications. The LVDS standard is becoming the most popular differential data transmission standard in the industry. This is driven by two simple features: Gigabits @ milliwatts! LVDS delivers high data rates while consuming significantly less power than competing technologies. In addition, it brings many other benefits, which include:

a)Low-voltage power supply compatibility
b)Low noise generation
c)High no ....etc

[:=Read Full Message Here=:]

applications of multi rate signal processing
multi rate signal processing applications in digital signal processing
applications of multi rate signal processing in digital signal processing
applications of multi rate signal processing in digital signal processing ....etc

[:=Read Full Message Here=:]

Challenges and Recent Advances in QoS Provisioning,
Signaling, Routing and MAC protocols for MANETs


Shivanajay Marwaha Jadwiga Indulska Marius Portmann
School of ITEE, University of Queensland and NICTA Queensland Research Laboratory
Brisbane, Australia



ABSTRACT
Mobile Ad hoc Networks (MANET), which comprise of
mobile nodes connected wirelessly, are emerging as a very
important technology for future generation of wireless
networking. MANETs are being us ....etc

[:=Read Full Message Here=:]

SYNOPSIS
Dual-tone Multi-Frequency (DTMF) signaling is the basis for voice communications control and is widely used worldwide in modern telephony to dial numbers and configure switchboards. It is also used in systems such as in voice mail, electronic mail and telephone banking.
The detector part of early DTMF systems consisted of analog implemented bandpass filter banks, which were tuned to the eight standard frequencies. As analog lines as well as many other analog systems were converted to digital, researchers became ....etc

[:=Read Full Message Here=:]

Mobile ad hoc networks (MANETs) are infrastructure-less and can be set up anywhere, anytime. They can host a wide range of applications in rescue operations, military, private, and commercial settings. Multimedia conferencing is the basis of a wealth of killer applications that can be deployed in MANETs. Some examples are audio/video conferencing, multiplayer games, and online public debating. Signaling is the nerve center of multimedia conferences”it establishes, modifies, and tears down conferences. This paper focuses on signaling for ....etc

[:=Read Full Message Here=:]

pls send me the reports,ppts,pdfs of signaling with multimedia conferencing in standalone mobile adhoc networks ....etc

[:=Read Full Message Here=:]

presented by:
KAMAL RAJ SINGH


Types of Signaling
Signaling in Telecommunications Network
Channel Associated Signaling (CAS)
Common Channel Signaling (CCS)
Channel Associated Signaling (CAS) :-
Used for In-Band Signaling .
Signaling is transmitted in the same frequency band as used by voice.
Common Channel Signaling (CCS):-
Out of Band signaling
Employs separate, dedicated path for signaling.
Voice trunks are used only when a connection is established, not before.
Faster Call Setup.
Signal ....etc

[:=Read Full Message Here=:]

hello everybody, i am ram prawesh kumar, student of final year of electronics & communication engneering.

i want complete circuit designing of Train Collision Prevention and Signaling using RF (means where is diode, transistor, resistor, capacitor, transformer, sensor, etc. are connected in bradbord to properly works for project of Train Collision Prevention and Signaling using RF).

if any one can help to make this project please mail me complete details on my email id - [email protected]


please any one help me
ram prawe ....etc

[:=Read Full Message Here=:]

SOME UNCONVENTIONAL SIGNAL PROCESSING APPLICATIONS OF MULTIRATE TECHNIQUES



INTRODUCTION
Multirate digital signal processing systems are characterized
by unequal sampling rates at various stages in the system. In
recent years, there has been a growing interest in the design
and applications of such systems. In most cases, the multirate
concepts have been used in some conventional applications
such as subband coding of signals, transfer of data to
and f ....etc

[:=Read Full Message Here=:]