my project aim is to improve the first swing stability limit..
i need information about how to reduce the bus admittance matrix to machine internal bus, how to create fault on multimachine power system, how to solve swing equation of multimachine power system using matlab coding ....etc

[:=Read Full Message Here=:]

ADAPTIVE AND NON-LINEAR EXCITATION CONTROL OF SYNCHRONOUS GENERATOR‟S STABILITY THROUGH NEURAL NETWORK

ABSTRACT
Adaptive and non linear Excitation control of synchronous generator‟s stability through Neural Network Control equipment of synchronous generators such as automatic voltage regulators, speed governors and power system stabilizers have been developed to maintain stability and to improve damping of the power systems. When an operating condition changes greatly, however, such controllers may become less effective b ....etc

[:=Read Full Message Here=:]

ENHANCEMENT OF VEHICLE STABILITY BY ACTIVE GEOMETRY
CONTROL SUSPENSION SYSTEM


1. INTRODUCTION

In recent years, there has been increased need to develop high-performance suspension for high-power engines ,especially active chassis control systems have been developed and mass-produced in the market to compromise vehicle ride and handling performance simultaneously,
The conventional active chassis control systems control the vehicle phenomenon such as body roll, yaw, and pitch using hydraulic actuators with the same directi ....etc

[:=Read Full Message Here=:]

hello i need ppt of helicopter stability and control ....etc

[:=Read Full Message Here=:]

i need a seminar work on power system stability studies ....etc

[:=Read Full Message Here=:]

hi.. is there any example for the simulation for this model in simulink? ....etc

[:=Read Full Message Here=:]

How to understand the Simulink messages on the ACLine parameters presented as following strings:
Resistances
Inductances ?
Are these r and x specific parameters (per unit length) or they relate to the full length of the line?
For an inductance do the values mean inductivity (L in henry) or
reactance (x = wL in Ohms) ?
The values at the end of strings are they in pu or something else ? ....etc

[:=Read Full Message Here=:]

AIRCRAFT STABILITY AND CONTROL



POWER EFFECT DUE TO JET PROPULSION

THERE ARE THREE MAJOR CONTRIBUTION
• DIRECT THRUST EFFECT
• DIRECT NORMAL FORCE EFFECT AT AIR DUCT
INTAKE
• INDUCED FLOW AT THE TAIL DUE TO THE
INFLOW TO THE JET BLAST
NOTE: THE ROCKET INSTALLATION WILL ENCOUNTER
FIRST TWO WHILE TURBOJET WILL ENCOUNTER ALL
THREE
....etc

[:=Read Full Message Here=:]

POWER SYSTEM STABILITY: NEW OPPORTUNITIES FOR CONTROL


I. Introduction
The power system networks in North America and Europe are the largest man-made
interconnected systems in the world. The Eastern Interconnection in North America that
stretches from the East Coast to almost the Rocky Mountains is the largest in terms of
geographic area covered, total installed generation capacity and total miles of transmission lines.
Moreover, all the rotating generators in one network rotate synchronously producing a ....etc

[:=Read Full Message Here=:]

hello
i need examples for using the extended equal area criteria for transient stability assessment for multi-machine powersystem
i need examples to determine critical clearing time for fault occur in power system to remain in stable case.
thanks
email:[email protected] ....etc

[:=Read Full Message Here=:]