Abstract
Purpose: This paper presents the properties of magneto-rheological fluids and their recent applications and development In recent years. This paper particularly deals about the use of MR fluids in shock absorbing system in cars.
Reviews: The theoretical research results of the properties and applications obtained in the past decades and their developments are also reviewed.
Findings: It is very clearly and well understood from the presented paper that replacement of the traditional methods w ....etc

[:=Read Full Message Here=:]

send it to me plz. i need it to be presented. send me the ppt and word doc as soon as possible.. ....etc

[:=Read Full Message Here=:]

Presented by:
Clyde Jonathan D’Silva


Super critical Fluids and its Applications
INTRODUCTION
• Definition: Supercritical Fluid is any substance at a temperature and pressure above its Critical point.
• Example: Commonly used Supercritical fluids are CO2 & H2O.
Phase Diagram:
• Few SCF
PROPERTIES OF SCF
• Can penetrate solids like gas.
• Dissolves materials like liquid.
• There is no surface tension in SCF.
• It has a very good solvent property.
• In supercritical en ....etc

[:=Read Full Message Here=:]

Hey guys, I'm a Mec undergraduate. Here's my request-->If anyone has information or any report/ppt on the above topic, kindly post them. I'll be grateful!

Regards,
eGeek
....etc

[:=Read Full Message Here=:]

The uniaxial extensional viscosity is a fundamental material property of a fluid which characterizes the resistance of a material to stretching deformations. For microstructured fluids, this extensional viscosity is a function of both the rate of deformation and the total strain accumulated. Some of the most common manifestations of extensional viscosity effects in complex fluids are the dramatic changes they have on the lifetime of a fluid thread undergoing capillary breakup. In a pinching thread, viscous, inertial and elastic forces can all r ....etc

[:=Read Full Message Here=:]

Electrorheological fluids are suspensions of extremely fine non-conducting particles (up to 50 micrometres diameter) in an electrically insulating fluid. The apparent viscosity of these fluids changes reversibly by an order of up to 100,000 in response to an electric field. For example, a typical ER fluid can go from the consistency of a liquid to that of a gel, and back, with response times on the order of milliseconds. The effect is sometimes called the Winslow effect

The ER effect

The change in apparent viscosity is dependent on the ap ....etc

[:=Read Full Message Here=:]

ABSTRACT

Materials Science research is now entered a new phase where the structure and properties of materials are investigated, characterized and controlled at the nanoscale. Though as sophisticated as their larger counterparts, these devices are still burdened because they rely on an outside power. The size of the entire device is determined by the size of the power source. Batteries and other traditional sources are too large, and tend to negate the size advantages of nano devices. Also, batteries being used at present ....etc

[:=Read Full Message Here=:]

nano fluids have higher heat transfer capability its obvious but the calculations are complex i need help ....etc

[:=Read Full Message Here=:]

Important two-phase fluid mechanics problems that are dominated or significantly affected by capillary effects are not oddities but rather daily events in our lives. Seemingly unrelated topics such as the economics of satellite television and pulmonary health and safety research share capillary fluids physics. Current and future miniaturized two-phase heat transfer loops and fuel cells possess similar concerns. This seminar presents research in a number of capillary fluids topics on Earth and in orbit. An energy method code, Surface Evolver, is ....etc

[:=Read Full Message Here=:]

Assessment of blends of CO2 with butane and isobutane as working fluids for heat pump applications
arun k
s7 m1
College of Engineering, Trivandrum
2007-11 Batch



Introduction
Eco-friendly natural refrigerants as alternative refrigerants

Due to toxicity of NH3, flammability of hydrocarbons, and high pressure and low COP of CO2, blends are mo ....etc

[:=Read Full Message Here=:]