The recent increase in the use of hard, high strength and temperature resistant materials in engineering necessitated the development of newer machining techniques. Conventional machining or finishing methods are not readily applicable to the new materials like hastalloy, nitralloy, waspalloy, nimonics, carbides, ceramics etc.


Conventional machining processes when applied to these newer materials:
1. Are uneconomical,
2. Produce poor degree of surface finish and accuracy,
3. Produce some stress,
4. Highly insufficient.

Newer machin ....etc

[:=Read Full Message Here=:]

i would like to get details on magneto abrasive flow machining ppt .. ....etc

[:=Read Full Message Here=:]

abstract on my seminar topic magneto abrasive flow machining.please send it immediately as i have to give seminar tomorrow on this topic. ....etc

[:=Read Full Message Here=:]

Can u please send me the detailed seminar report and the ppt of the topic Magneto Abrasive Flow Machining ....etc

[:=Read Full Message Here=:]

sir i am aiyaz ulla khan studying BE final semester and i want to give a seminar on magneto abrasive flow machining so would please send me the full report of the above topic and alsothe ppt releated to it .my email id is [email protected] sir please send a confirmation about posting report to me till today night because tommoro its last day to finalize the topic to my seminar co ordinator'it will be greatfull to me '. please dont mind sir.
thankyou

aiyazull ....etc

[:=Read Full Message Here=:]

sir please send me some ppt on magneto abbrasive flow machining
....etc

[:=Read Full Message Here=:]

I needed the full details of the topic Magneto abrasive flow machining for my seminars. I also want the information about the recent new development of this process too.
so i request u to get me the same as soon as possible.
i would want to get the details and the ppt of the topic also.
I needed the full details of the topic Magneto abrasive flow machining for my seminars. I also want the information about the recent new development of this process too.
so i request u to get me the same as soon as possible.
i would want to get the details ....etc

[:=Read Full Message Here=:]

I am choto kumar ,
I want a full seminar of the topic Magneto Abrasive Flow Machining .I want a pdf file with diagram of the above topic.
i am doing btech in mechanical engg, i have to give a seminar of the above topic on sept 6. if u give me some guidence then i will do well in seminars.

....etc

[:=Read Full Message Here=:]

Respected sir ,
Sub : to ask about magneto abrasive flow machining and relative cost ..

sir plzz guide me about the set up of magneto abrasive flow machining process and tell me is the relative process is costly or not as it concider under a project wok ?? ....etc

[:=Read Full Message Here=:]

Hi sir,
I am ashok I am doing project on carpooling in tgmc project and can i get the code or any help in implementing this project through
Technologies to beused
UML, J2EE, XML, AJAX, Spring, Struts, Hibernate.
Tools to be Used
ROSE/RSA / WebSphere Modeler
Eclipse/ RAD / Lotus Forms Designer / Portlet Factory
my email id [email protected]
thanking [email protected] ....etc

[:=Read Full Message Here=:]