I AM A PROFFESSOR OF MICROBIOLOGY .
I WANT URGENTLY THE LIST OF BENIFICIAL BACTERIAS PRESENT IN AEROBICALLY TREATED DISTILLERY EFFLUENT.
ALSO I WANT URGENTLY TO KNOW THE NAMES OF PARTICULAR BACTERIAS RESPONSIBLE FOR DISCOLOURISATION OF DISTILLERY EFFLUENT. ....etc

[:=Read Full Message Here=:]

Requesting for ground water recharge through treated wastewater ppt.

Regards,

Nadeem Khalil ....etc

[:=Read Full Message Here=:]

Abstract

Rapid urbanization has resulted in drastic increase in housing demand today. The traditional or conventional method of construction for mass housing is comparatively, a slow process and has limited quality control, particularly when a large size project is involved. It is therefore obligatory to work out a method or a scheme where the speed and quality of construction are controlled automatically by a systematic approach. Many methods have emerged and have been tried out and are still being adopted ....etc

[:=Read Full Message Here=:]

Jet impingement heat transfer – Part I: Mean and root-mean-square heat transfer and velocity distributions
Abstract
Impinging jets provide a means of achieving high heat transfer coefficients both locally and on an area averaged basis. The currentwork forms the first stage of a two part investigation of heat transfer distributions from a heated flat surface subject to an impinging airjet for Reynolds numbers from 10,000 to 30,000 and non-dimensional surface to jet exit spacing, H/D, from 0.5 to 8. In the present paper,the rel ....etc

[:=Read Full Message Here=:]

DjtmtjapjmTjdgumjpxjgugumjpupvdmtpgmtpglngjmtpgajptnjgtwjpuwdjgpm ....etc

[:=Read Full Message Here=:]

High Conductance Heat Transfer Using Solar Heat Pipe Collector

presented by :-
MR. SHIVAJI D. YADAO1, MR. PRMENDRA J BANSOD2
Dr. D.Y.Patil Institute of Engg. & Tech.,Pune University, Pune,
Dr. D.Y.Patil Institute of Engg. & Tech.,Pune University, Pune,

abstract
In recent years it has become increasingly important to develop methods for efficient transport of thermal energy from one location to another. Moreover the advent of the space age has stimulated research for heat transfer devices which are ....etc

[:=Read Full Message Here=:]

Presented by:
A.JohnBritto
C.Kanaga Raj
P.Senna Kesavan
A.VinothHEAT TRANSFER PERFORMANCE IN 3D INDUCED FINNED HEAT PIPE

ABSTRACT
3D induced finned steel-water heat pipe is carried out in this project.

All the main parameters that can significantly influence the heat transfer performance of heat pipe ,such as working temperature, heat flux, inclination angle, working fluid fill ratio (defined by the evaporatio ....etc

[:=Read Full Message Here=:]

Particle reinforced MMC?s are now being produced commercially and in this paper the various processing techniques used for the production of aluminium composites and factors affecting their quality are overviewed. The various techniques like powder metallurgy, spray deposition, molten metal infiltration, molten metal mixing, liquid metallurgy, compo-casting technique etc. The factors affecting the uniform dispersion of the composites and the various properties of the metal matrix composites are also discussed. Aluminium alloy matrix particulate ....etc

[:=Read Full Message Here=:]

PRESENTED BY:
AVINANDAN SANDILYA


ALUMINIUM AND ITS ALLOYS
INTRODUCTION
 It is the third most abundant element of 8% on earth crust and normally found in oxide forms. It is a non-ferrous metal.
 It does not occur free in nature.
 Therefore it remained unknown until the nineteenth century.
ORES OF ALUMINIUM
ALLOYS OF ALUMINIUM
Designations of wrought aluminium alloys
Non-heat-treatable alloys
1xxx series (Super-purity and commercial-purity aluminium)
3xxx series (Al-Mn a ....etc

[:=Read Full Message Here=:]

i want this seminar of aluminium alloys heat treatment ....etc

[:=Read Full Message Here=:]