What is the role of CVT in PLCC.Kindly explain through Circuit diagram. ....etc

[:=Read Full Message Here=:]

My name is rajan i am not able to open connect page please tell me the reason ....etc

[:=Read Full Message Here=:]

ABSTRACT
The I-Connect is an application that has been developed for a well-established regional bank operating primarily in south India. The bank has several branches in key cities and towns in the north. In the world of this competitive environment and technological development, the bank has been totally computerized in the last 3 years, and to increase its customer base has started planning, for a concept called as e-banking; with this concept the bank wants to move very nearer to the customers and increase its ba ....etc

[:=Read Full Message Here=:]

ABSTRACT

Point&Connect (P&C) offers an intuitive and resilient device pairing solution on standard mobile phones. Its operation follows the simple sequence of point-and-connect: when a user plans to pair her mobile phone with another device nearby, she makes a simple hand gesture that points her phone towards the intended target. The system will capture the user’s gesture, understand the target selection intention, and complete the device pairing. P&C is intention based, intuitive, and reduces user efforts in device pairing. The ....etc

[:=Read Full Message Here=:]

PLCC.



Outdoor equipment:-

1. Wave trap:- These are used for blocking the HF signals of PLCC entering into substation. Wave traps will allow only high voltage power signal of 50Hz frequency.

2. Line matching (LMU):- The output of PLCC is connected to the LMU then to the power lines to achieve proper impedance matching between PLCC equipment and power lines.

3. Capacitance voltage transformer/Capacitor coupling (CVT/CC):-
(C ....etc

[:=Read Full Message Here=:]

Hello this is Astika, I am a final year student at the University of Mauritius in the BEng Electronic and Communication Engineering programme and I am currently doing my degree project on Network Security. The aim is to enhance the IDS Snort and making a testbed for network training and simulation. I would really welcome help on how to connect Snort with Matlab and simulate a testbed for the enhanced Snort, and implementing the attacks as well.
Thanks in Advance ....etc

[:=Read Full Message Here=:]

pls provide me the working of phase to ground coupling and phase to phase coupling coupling in PLCC.
....etc

[:=Read Full Message Here=:]

how to interface microcontroller at89s52 and max232 and eeprom ....etc

[:=Read Full Message Here=:]

PLCC OVERVIEW :

PRESENTED BY BIMAL NANDA



PLCC Technology


PLCC system uses the same High Voltage transmission line connecting two sub-stations for telecommunication purpose too.
PLCC is used in all power utilities as a primary communication service to transmit speech, telemetry and protection tripping commands. This is economic and reliable for inter grid message transfer as well as low bit rate RTU signals.
The voice/data are mixed with radio frequency carrier (40- ....etc

[:=Read Full Message Here=:]

I just got a new wireless modem from mtnl but the problem is that I
have IPTV so I have to disable the DHCP. without which the wifi dosn't work
so I cannot connect my phone to the Modem.
If i enable the DHCP my IPTV will not work.
So I am in a bind either watch TV or Have broadband wifi on my mobile.
Can anyone please solve this problem.
Regard
Mahesh Shervegar ....etc

[:=Read Full Message Here=:]