Study of the mechanical behaviour of a macroscopic
glass–polyester composite by ESPI method and numerical simulations


Alberto Corigliano a, , Enrico Papa a, AndreaPavan

Department of Structural Engineering, Politecnico di Milano, Piazza Leonardo da Vinci, 32. 20133 Milano, Italy
b Department of Chemistry, Materials and Chemical Engineering ‘‘Giulio Natta’’, Piazza Leonardo da Vinci, 32. 20133 Milano, Italy


Abstract
This paper presents results of an experimental ....etc

[:=Read Full Message Here=:]

ENGINEERING BEHAVIOUR OF STABILIZED PEAT SOIL


INTRODUCTION
Peat and organic soil represents the extreme form of soft soil.
At its initial state peat has high compressibility and water holding capacity, low

specific gravity and medium to low permeability .
Consequently it is widely regarded as a problematic soil .
In practice it is economical to stabilize the soil by dry mixing the soil with binder

to form columnar reinforcement in deep peat ground .

DEFENITION
PEAT SOIL
Peat soils are f ....etc

[:=Read Full Message Here=:]

pls give the ppt file of this topic ....etc

[:=Read Full Message Here=:]

Microbotics(ormicrorobotics) is the field ofminiaturerobotics, in particular mobile robots with characteristic dimensions less than 1 mm. The term can also be used for robots capable of handling micrometer size components.While the 'micro' prefix has been used subjectively to mean small, standardizing on length scales avoids confusion. Thus a nanorobot would have characteristic dimensions at or below 1 micrometer, or manipulate components on the 1 to 1000 nm size range. A microrobot would have characteristic dimensions less than 1 millimeter, ....etc

[:=Read Full Message Here=:]

Prepared by:
ANUPAMA SAHU


Abstract

Alumina-Titania coatings are excellent candidates for providing protection against abrasive wear and resistant to high temperature erosion. Such coatings are desirable in electrical insulation and anti-wear applications; viz. as protective coatings for sleeve shafts, thermo-couples jackets, pump shafts e.t.c.
Plasma spraying is gaining acceptance as a development of quality coatings of various materials on a wide range of substrates. Coatings made with plasma rout ....etc

[:=Read Full Message Here=:]

Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

i need full paper of this topic ....etc

[:=Read Full Message Here=:]

Construction material subjected to repetitive or cyclic loading have to be qualified for their fatigue behaviour. Generally their behaviour is considered satisfactory if they withstand two million cycle of repetitive loading without distress or failure at that required mean stress level and range stress.
The recent research in reinforcing Portland cement based material with randomly distributed fibres was spurred by pioneering research or fibre reinforced concrete (FRC) conducted in the United state in the 1960s.The addition of fibre in the co ....etc

[:=Read Full Message Here=:]

Boids, developed by Craig Reynolds in 1986, is an artificial life program, simulating the flocking behaviour of birds.

As with most artificial life simulations, Boids is an example of emergent behaviour; that is, the complexity of Boids arises from the interaction of individual agents (the boids, in this case) adhering to a set of simple rules. The rules applied in the simplest Boids world are as follows:

*
separation: steer to avoid crowding local flockmates
*
alignment: steer towards the average heading of local f ....etc

[:=Read Full Message Here=:]

Buying: Behaviour and Promotion in Textile Retailing in Kerala
*Dr.MolLRKoshy
**SureshN.
INTRODUCTION
Retail outlets are the main source of purchase for consumers. Around 80 percent of the customers buy goods
from retailers, while 20 percent goes to the wholesalers and manufacturers. Textile retailing in Kerala used to be a
business that earned huge profits with leas investment. But today the situation has changed. To earn a meager profit
huge investment is needed. Earlier the customers were not bothered about the ambience of the shop an ....etc

[:=Read Full Message Here=:]