wireless equipment control using at89c5l project document ....etc

[:=Read Full Message Here=:]

Hello this is Astika, I am a final year student at the University of Mauritius in the BEng Electronic and Communication Engineering programme and I am currently doing my degree project on Network Security. The aim is to enhance the IDS Snort and making a testbed for network training and simulation. I would really welcome help on how to connect Snort with Matlab and simulate a testbed for the enhanced Snort, and implementing the attacks as well.
Thanks in Advance ....etc

[:=Read Full Message Here=:]

ABSTRACT
Here is a microcontroller based wireless equipment controller that can switch on or off upto four devices at a desired time interval set by the user in the transmitter. The devices can be controlled remotely from a distance upto 30 metres from the transmitter. In the transmitter, an LCD module is used to show the device numbers and preset control time for the devices (00 to 99 seconds). The 8-bit AT89C51 microcontroller is the main controlling part of the transmitter section. It is connected to the LCD modu ....etc

[:=Read Full Message Here=:]

ABSTRACT
The I-Connect is an application that has been developed for a well-established regional bank operating primarily in south India. The bank has several branches in key cities and towns in the north. In the world of this competitive environment and technological development, the bank has been totally computerized in the last 3 years, and to increase its customer base has started planning, for a concept called as e-banking; with this concept the bank wants to move very nearer to the customers and increase its ba ....etc

[:=Read Full Message Here=:]

ABSTRACT

Point&Connect (P&C) offers an intuitive and resilient device pairing solution on standard mobile phones. Its operation follows the simple sequence of point-and-connect: when a user plans to pair her mobile phone with another device nearby, she makes a simple hand gesture that points her phone towards the intended target. The system will capture the user’s gesture, understand the target selection intention, and complete the device pairing. P&C is intention based, intuitive, and reduces user efforts in device pairing. The ....etc

[:=Read Full Message Here=:]

I AM SEARCHING FOR CIRCUIT DIAGRAM OF MICROCONTROLLER AT89C51 BASED AUTO SPEED LIMITER WITH AUTO BREAKING ....etc

[:=Read Full Message Here=:]

I just got a new wireless modem from mtnl but the problem is that I
have IPTV so I have to disable the DHCP. without which the wifi dosn't work
so I cannot connect my phone to the Modem.
If i enable the DHCP my IPTV will not work.
So I am in a bind either watch TV or Have broadband wifi on my mobile.
Can anyone please solve this problem.
Regard
Mahesh Shervegar ....etc

[:=Read Full Message Here=:]

how to interface microcontroller at89s52 and max232 and eeprom ....etc

[:=Read Full Message Here=:]

I have made the project of wireless equipment control using at89c51 but I am facing the following problems.

1 In the project the 16X2 lcd display is not showing any display even after loading the program in controller. It just shows 16 square boxes on screen instead if showing the display of setting time for four LED.

2 Ideally Pin no 17 of TRX434 should have high logic (5v) to transmit the signal to the receiver . But at pin no 17 I am getting the voltage between 0 to 1 V.

....etc

[:=Read Full Message Here=:]

My name is rajan i am not able to open connect page please tell me the reason ....etc

[:=Read Full Message Here=:]