I need project write up for trainer development kits for 8051 micro controller for bginners
....etc

[:=Read Full Message Here=:]

An embedded system is a special-purpose system in which the computer is completely encapsulated by the device it controls. Unlike a general-purpose computer, such as a personal computer, an embedded system performs one or a few pre-defined tasks, usually with very specific requirements. Since the system is dedicated to specific tasks, design engineers can optimize it, reducing the size and cost of the product.

http://ziddudownload/5571379/Automotivebasedmanag.rar.html ....etc

[:=Read Full Message Here=:]

Prepared by::BHIMRAO




INTRODUCTION
The potential of cryogenic energy storage for automotive propulsion as an alternative to the electrochemical batteries for zero-emission vehicles (ZEV).
It is anticipated that use of an inert cryogen, such as liquid nitrogen(LN2), as an energy storage would not pose any environmental burden, and in particular would avoid the issues of heavy metals pollution associated with lead-acid batteries.

CRYOGENIC POWER CYCLE
The cryogen “fuel” is st ....etc

[:=Read Full Message Here=:]

This is Neeraj Mundada.
I have a basic idea about automobile automation for 4-wheeler.
pls Send me the documentation and UML diagrams for it ....etc

[:=Read Full Message Here=:]

Abstract:
In this paper, we have described a successful approach to enhancing an advanced engineering automotive course via the addition of numerical simulation using Matlab. The main objective of the paper is to show the usefulness and power of Matlab in modeling and analyzing dynamic behavior of vehicle subsystems. The second purpose of this paper is to present the advantages of using Matlab to simulate these systems. Tutorial problems in arrears of analysis and control of suspension responses for the quarter car ....etc

[:=Read Full Message Here=:]

K. Wojciechowski, J. Merkisz, P. Fuć
, P. Lijewski, M.Schmidt


Abstract
Automotive engines reject a considerable amount of energy to the ambience through the exhaust gas. Significant reduction of engine fuel consumption could be attained by recovering of exhaust heat by using thermoelectric generators. One of the most important issues is to develop an efficient heat exchanger which provides optimal recovery of heat from exhaust gases. The work presents a design and perform ....etc

[:=Read Full Message Here=:]

hi I am Biju.I want to know about the swg size of coil ....etc

[:=Read Full Message Here=:]

Gary Morphy
VARI-FORM

ABSTRACT
The need for lighter, stronger, more rigid vehicle structures will increasingly require complex hydroformed structural tubes to increase strength, and decrease weight, cost and part count. This effort will increase the use of high strength, low alloy (HSLA) steel, in place of SAE 1006/1008 or 1010 steel. Traditional hydroforming techniques require the higher elongation of the latter materials. An alternative tube hydroforming process has been d ....etc

[:=Read Full Message Here=:]

GAS LEAKAGE ALERT & PROTECTION SYSTEM project report ....etc

[:=Read Full Message Here=:]

An Optimized Low Heat Rejection Engine for Automotive Use - An Inceptive Study
GOVERNMENT OF KERALA
DEPARTMENT OF TECHNICAL EDUCATION

Govt. Rajiv Gandhi Institute of Technology


ABSTRACT
An unconventional low heat rejection (LHR) engine design is described. Previous research efforts into LHR concepts, including high temperature materials and tribology, are reviewed. The continued reliance on conventional compression ignition designs is identified as a significant roadblo ....etc

[:=Read Full Message Here=:]