ABSTRACT
A new generation of small scale (less than 20 MWe) biomass fueled, power plants are
being developed based on a gas turbine (Brayton cycle) prime mover. These power plants
are expected to increase the efficiency and lower the cost of generating power from fuels
such as wood. The new power plants are also expected to economically utilize annual
plant growth materials (such as rice hulls, cotton gin trash, nut shells, and various straws,
grasses, and animal manures) that are not normally considered as fuel for power plants.
This p ....etc

[:=Read Full Message Here=:]

plz give me the details of microcontroller based lithium ion battery charger with automated charge and discharge cycles ,circuit diagram and other details:)
....etc

[:=Read Full Message Here=:]

i am rahul , doing M.Tech from SVNIT surat. i know the basics of EGR of gas turbine engines. i want the full project report ....etc

[:=Read Full Message Here=:]

Design of p-Cycles for full node protection in WDM Mesh Networks



INTRODUCTION

WDM techniques enable a single fiber to carry multiple
non-overlapping channels, and a single channel can operate
at the speed of up to 100 Gbps. WDM networks carry huge
amounts of traffic. As optical WDM networks are occasionally
prone to a single failure of network infrastructure (e.g., a fiber
cut or a node failure), survivability is an essential requirement
in the design of WDM networks.
....etc

[:=Read Full Message Here=:]

4 THERMODYNAMIC CYCLES



Abstract

Energy sources such as coal, natural gas, or petroleum cannot be used directly to
perform a work. These sources are burned to generate heat which is then converted to
mechanical or electrical energy. These processes are governed by thermodynamic
cycles and the efficiency of the overall process depends mainly on the choice or
efficiency of the cycle. A number of thermodynamic cycles using various working
fluids have been suggested. The description and analysis of these c ....etc

[:=Read Full Message Here=:]

pls send me as soon as possible ....etc

[:=Read Full Message Here=:]

AIR STANDARD CYCLES


Theoretical Analysis

The accurate analysis of the various processes taking place in an internal combustion engine is a very complex problem. If these processes were to be analyzed experimentally, the analysis would be very realistic no doubt. It would also be quite accurate if the tests are carried out correctly and systematically, but it would be time consuming. If a detailed analysis has to be carried out involving changes in operating parameters, the cost of such an analysis ....etc

[:=Read Full Message Here=:]

The gas turbine has been an enormously successful power plant for aircraft and marine propulsion, and electric power generation, due to its lightweight, smooth and reliable operation, low emissions, and varied applications. Nevertheless, it is not very efficient in converting fuel energy to useful work, due to fundamental thermodynamic limitations imposed by turbo machinery technology.

In recent years, there is renewed interest in the potential high efficiency of alternative thermodynamic cycles and unsteady combustion systems for propul ....etc

[:=Read Full Message Here=:]

Single-link failure detection in all-optical networks using monitoring cycles and paths

In this paper, we consider the problem of fault localization in all-optical networks. We introduce the concept of monitoring cycles (MCs) and monitoring paths (MPs) for unique identification of single-link failures. MCs and MPs are required to pass through one or more monitoring locations. They are constructed such that any single-link failure results in the failure of a unique combination of MCs and MPs that pass through the monitoring location(s). For ....etc

[:=Read Full Message Here=:]

I.C. Engine Cycles or Thermodynamic Analysis




....etc

[:=Read Full Message Here=:]