Hi
I am a graduate student of electrical engineering, power electronics trends. My seminar topic is multipleinput dc Converters. If it is possible give useful content.
Thanks ....etc

[:=Read Full Message Here=:]

The dream of every communication designer is to provide good quality service to each of his customer within the limited available bandwidth. But in the recent years, the amount of data flowing through the channel has increased. But there has been no such high increase in the available bandwidth. So it is a challenge to effectively utilize the channel spectrum along with providing good quality of service across wireless links. One of the possible ways is to use multiple antennas at both the ends of the transmission link. MIMP exploits natural ph ....etc

[:=Read Full Message Here=:]

I am doing my M.tech in power electronics division.This is karthik....
I want designing aspects of buck boost matrix converter.Currently I am simulating the circuit.hardware design calculations of buck boost matrix converter is required.
Designing aspects means calculation of component values.... ....etc

[:=Read Full Message Here=:]

help me on building buck-boost converter to control dc motor plz ....etc

[:=Read Full Message Here=:]

looking for state space modeling of boost converter using matlab ....etc

[:=Read Full Message Here=:]

mini project on design of buck-boost converter ....etc

[:=Read Full Message Here=:]

.................................................aAAAAAAAaaaaaaaaaaaaaaa ....etc

[:=Read Full Message Here=:]

A Multiple-Input Dc-Dc Positive Buck-Boost Converter Topology

Abstract-
A new multiple-input hybrid energy conversion topology is presented. The proposed topology is capable of combining different energy sources with different voltage-current characteristics, while achieving low part number and bi-directional operational. Compare to previous multiple-input buck-boost converter, the proposed topology provides positive output voltage; it is capable of bi-directional operation; and it has the capability of operating in buck, boost, and buc ....etc

[:=Read Full Message Here=:]

dear sir/madam plz send me the project report of a single phase z source buck boost matrix converter. my mail id is [email protected] ....etc

[:=Read Full Message Here=:]

DC−DC Buck/Boost Converter
Buck/Boost converter
This circuit is more unforgiving than the boost converter, because the MOSFET and diode voltages and currents are higher
• Before applying power, make sure that your D is at the minimum, and that a load is solidly connected
• Limit your output voltage to 90V
KVL and KCL in the average sense
Interestingly, no average current passes from the source side, through C1, to the load side, and yet this is a “DC - DC” converter
Inductor L1 current ratin ....etc

[:=Read Full Message Here=:]