Hi,
I'm an electrical engineering student and would like to control a Sepic converter using fuzzy logic on MOSFET switch. I use matlab / simulink. I already have almost everything ready, the problem is that I can’t find the right inference rule to stabilize the control in 9,6V being that the input source is a solar panel ranging from 5 to 15,5V. Do you have any rule to Sepic logic control using fuzzy logic? Even a surface chart serve. Or a fuzzy simulation file type fis.. Thank you. ....etc

[:=Read Full Message Here=:]

input voltage = 48V,output voltage = 700v,input frequency = 500000.

What is the value of Duty cycle= ? L1a=?, L1b=?, R(load)=?,C(out)=?
....etc

[:=Read Full Message Here=:]

ppt for nonisolated high stepup boost converter integrated with sepic converter ....etc

[:=Read Full Message Here=:]

non isolated high step up boost converter integrated with sepic converter matlab simulink model ....etc

[:=Read Full Message Here=:]

i want to do a project in sepic converter for speed control. ....etc

[:=Read Full Message Here=:]

hello .I want the model to simulate an isolated SEPIC.thanks ....etc

[:=Read Full Message Here=:]

Designing A SEPIC Converter




Introduction

In a SEPIC (Single Ended Primary Inductance Converter) design,
the output voltage can be higher or lower than the input
voltage. The SEPIC converter shown in Figure 1 uses two
inductors, L1 and L2. The two inductors can be wound on the
same core since the same voltages are applied to them
throughout the switching cycle. Using a coupled inductor
takes up less space on the PCB and tends to be low ....etc

[:=Read Full Message Here=:]

DESIGN A SEPIC CONVERTER WITH INPUT 5V, OUTPUT 1A,2V &8V ....etc

[:=Read Full Message Here=:]

Respected sir,
please send the ppt and report in this paper for my project.




thank u ....etc

[:=Read Full Message Here=:]

i am looking for sepic converter matlab simulink free download
help me, please ....etc

[:=Read Full Message Here=:]